Crown Bermuda, Информационный лист

Страница: 2 / 4

■ ■
Cast iron heat exchanger with
a 12-year limited warranty
■ ■
Stainless steel burners with
a lifetime limited warranty
■ ■
Tappings permit installation of
Mega-Stor indirect water heater
■ ■
Isolation relay simplifies
thermostat wiring
■ ■
Standing pilot or electronic
ignition available
■ ■
Appliance quality, powder-coated jacket
■ ■
Automatic vent damper*
■ ■
Fiber-glass insulation to minimize
wasteful heat loss
■ ■
Base and flue constructed of aluminized
steel for corrosion resistance
■ ■
Drain valve
■ ■
Built-in draft diverter allows boiler
to fit into low spaces
■ ■
Ten sizes from 69,000 to 379,000 BTU
input to serve a range of applications
from small residential to commercial
■ ■
Optional 5 or 10 year extended parts
and labor warranty coverage
✔
✔
✔
✔
✔
✔
✔
✔
✔
✔
✔
✔
■ ■
Fully assembled – ready for installation
or available as a knock-down package
■ ■
Factory tested for flame quality, leaks,
control system operation and overall
performance
■ ■
Probe or float low-water cut-off or optional
low-water cut-off/feeder combination
■ ■
“Redundant” gas valve
■ ■
Spill switch detects venting problems
■ ■
Rollout switch detects heat exchanger
blockage
■ ■
Gauge glass
■ ■
ASME pop safety valve (set at 15 psi.)
■ ■
Can be installed on combustible floors
For Safety:
✔
✔
✔
✔
✔
✔
✔
✔
✔
Bermuda gas-fired steam boilers provide
a wide range of sizes that can efficiently service
single family homes, multi-family residences
and small businesses. An approved chimney
is required.
Crafted with rugged, cast iron heat exchangers
and stainless steel burners, the Bermuda offers
proven-in-service reliability, simplicity of design
and economy in its purchase price and
consumption of fuel.
The heat exchangers are built with
steel push nipples below the water
line where superior strength and
resistance to expansion and contrac-
tion is important, and cast iron push
nipples above the water line where
corrosion resistance is key. The
cast iron push nipples are larger
than usually found on such units
to provide optimum steam quality.
Attractive and durable, the powder-
coated jacket resists scratching. Plus,
it’s insulated to retain heat.
The Bermuda meets all national
standards, and the heat exchanger
meets the specifications of the
American Society of Mechanical
Engineers.
Bermuda is the latest in a series
of designs that CROWN engineers
have created for ease of use,
constructed for long life, convenient
to install and service, and engineered
to provide the most value for each
energy dollar.
For Performance:
✔
*BSI069 thru BSI276