Crown 2/300, Руководство по эксплуатации, Страница: 19 / 91

Page 17
CDi DriveCore Series Operation Manual
Configuring the Amp
Delay
The CDi DriveCore amplifiers have an Input Delay (pre-crossover) and Output Delay (post-
crossover) DSP module for each channel. Each is selectable when navigating the Edit DSP
screen (see
Figure 17
). Once an Input or Output Delay module has been selected, delay
settings can be edited from the Delay screen (see
Figure 18
).
The Output Delay can be used to time-align the various drivers in a multi-way speaker
system. A total of up to 100ms of delay time is available in each Output Delay. The Input
Delay can be used for delaying the system to the stage backline, delay fills, or whenever
more delay time is required than the Output Delay has to offer. The Input Delay provide an
additional 1 second of delay time for each channel. Delay can be adjusted in milliseconds,
feet, or meters.
To edit delay settings:
1� From the Home screen, press the MENU button.
2� Select the "Configure Amplifier" option from the menu using the ENCODER .
3� Select the "Edit DSP" option from the menu.
4� Select the "Input Delay" or "Output Delay" icon for the channel you wish to edit.
5� Use the ENCODER to navigate, make selections, and edit settings.
6� When done, select "Done" at the bottom of the screen.
Available options/parameters:
• Enable (Off, On)
Turns the Delay on or off.
• Seconds (Input Delay: 0 – 1sec, Output Delay: 0 – 100ms)
Adjusts the delay time in milliseconds.
• Feet (Input Delay: 0 – 1127ft, Output Delay: 0 – 112�7ft)
Adjusts the delay time in feet.
• Meters (Input Delay: 0 – 343m, Output Delay: 0 – 34�3m)
Adjusts the delay time in meters.
For information on editing these settings in Audio Architect, see
"Input/Output Delay Panels" on page 40
.
Figure 18:
Delay screen