Arm to Output
1.
Enter the
Installer
mode.
on page 11 for instructions on how to enter this
mode.
2.
Press the ◄ button to confirm.
3.
Press the ▲or ▼ button to choose the Output you want to assign for arming the
C.P.
4.
Press the ◄ button to confirm.
NOTE
While you assign one Output to Arm this Output will not activated if one of the
detectors is in Alarm and a long beep will be heard to indicate that the Arm isn't
allowable. If all zones are sealed the output will activate and few beeps will hear for
success. Notice that ARM to OUTPUT feature can programmed to an output if no
detector was defined in this output in any Group either.
Buzzer Tie
1.
Enter the
Installer
mode.
on page 11 for instructions on how to enter this
mode.
2.
Press the ◄ button to confirm.
3.
Press the ▲or ▼ button to choose Yes or No.
4.
Press the ◄ button to confirm.
