BA_Migros_GB_s1bis32 11.02.2009 12:49 Uhr Seite 20
Probedruck
20
Handle bar bearing
Check:
– Apply the brake for the front wheel and move the cycle forward
and backward.
If there is too much tolerance due to wear and tear, the bearing
must be adjusted without delay.
The adjustment should be done by a specialized workshop.
Lighting system
The CROSSWAVE Pedelec is equipped with a lighting system that
draws power from the drive battery. It is switched on and off
via a switch on the front headlight (Figure 14). An electronic
circuit in the headlight converts the 25V of the drive battery
into 6V for the light.
As the power requirement of the bicycle lighting is very low, a
light left on would last about 2-3 days. Moreover, the protective
electronic circuit prevents a depth discharge of the battery if
the light remains switched on inadvertently.
Figure14
Caution!
Nevertheless, always switch the light
off while parking the Pedelec else you might
suddenly find the battery empty.
Figure 15
Spokes
The spokes expand and become loose in course of time. They
must be centred regularly according to the degree of use.
The centring of the wheel and tightening of the spokes should
be entrusted to a specialized workshop.
A uniform and proper
tightening of the spokes is necessary for a uniform rotation of
the wheels. Loose spokes, non-uniform spanning or overload
may lead to broken spokes.
Operating instructions
