7 - 7
After Installation/Adjustment
Flush the toilet two to three times to confirm
that
there
is no
water leakage and that the push mechanism is
working
properly.
6) Connect the opposite end of the water supply hose to
the angle stop (
s
ee
F
igure 5).
It is r
ecommended
to use
a
flexible supply hose. Hand tighten only - do not use
plumbers putty or other sealants. Open the supply valve
and flush the toilet several times. Check all the
connections for leaks and periodically afterwards
following the installation.
Minimum supply pressure is 2.6psi.
Figure 5
STEP 1
STEP 2
5"
7"
STEP 3
STEP 4
STEP 5
TOOLS NEEDED:
1.
Remove
the
tank lid. Disconnect the flapper chain/linkage from
the
lever. Unthread
the
nut from
the
old lever. Remove
the
lever from tank.
2.
For standard front-mount tanks go to step
3
. For a SIDE OR
ANGLE-MOUNT TANK, slowly bend
the
new lever arm to
match
the shape of the old lever arm. DO NOT BEND
THE
ARM
QUICKLY OR BACK AND FORTH REPEATEDLY.
3.
Measure length of
the
existing lever arm. If necessary, trim
the
new
arm at the cut line that best matches the length of the
old arm
(
a
hacksaw
is
recommended for best results).
4.
Slide
the
arm through
the
tank hole until
the
handle shank fits
snugly. Slip
the
lock nut over
the
lever (flat side facing
handle). Start
the
nut on
the
threads (reverse thread).
DO NOT TIGHTEN FULLY.
5.
Connect
the
flapper chain/linkage to
the
arm hole that
provides the
best lift.
The c
hain should have
a
slight slack
when
the
flapper is in the
closed position. Check
the
lift action
for proper flush. Tighten
the
lock
nut.
DO NOT OVERTIGHTEN
,
overtightening may crack
the
tank
and void the warranty
.
Warranty
-
Chinaware
: Limited lifetime
, Commercial: 1 year
Mechanical parts
: 5 years
, Commercial: 1 year
For further information contact
:
Crosswater London
, 393 Fortune Blvd., Milford, MA 01757
Toll free number: 844-XWATER-1 (844-992-8371) tel: 508-381-0433 fax: 508-381-6068
For full details, terms and conditions
please
visit our website.
crosswater
london.
com
email: technical@crosswater
london
.com
Issue date:
1012
2
0
19
Trip Lever
Installation Instruction
s
DO NOT USE:
CLEANING INSTRUCTIONS
A mild detergent, warm water and a soft cloth will remove normal dirt and soap accumulations from surfaces. Soft abrasive cleaners may be used on
vitreous china. Never use abrasive cleaners without water. Do not use caustic cleaners or disinfectants as they can alter the surface finish and void the
warranty.
Use toilet bowl cleaners on the inside of the bowl only. Remove any splashes of cleaner solution from plastic or plated surfaces immediately.
Do not use in-tank cleaners as they can seriously damage the fittings in the tank. This damage could cause leakage and result in property damage.
Crosswater London
shall not be responsible or liable for any damage that occurs as a result of the use of in-tank cleaners.
Do not allow certain materials such as toothpaste, cologne, shaving cream, nail polish remover, vinegar, wine, drain and glass cleaners to remain on
the surface. Prolonged contact can alter surface finishes and void the warranty.