Warranty
-
This
Crosswater London
product is covered by a limited lifetime warranty. For full details, terms and conditions please visit our website.
For further information contact
:
Crosswater
London
,
393 Fortune Blvd., Milford, MA 01757
Toll free number: 844-XWATER-1 (844-992-8371) tel: 508-381-
0433
fax: 508-381-6068
www.crosswater
london
.com
email: technical@crosswater
london
.com
Issue date:
15092019
NOTE:
For illustration
purposes
cross handle
shown.
INDICE
RETAINING
SCREW
CROSS HANDLE
CROSS HANDLE
SINGLE-HOLE
MIXER
STEEL BRAIDED
HOSES
LEVER
LEVER
VALVE COVER
RUBBER SEAL
CHROME COLLAR
STUD
RETAINING NUT
WASTE
OUTLET
HORSESHOE
PLATE
POP-UP
ROD
CARTRIDGE
Replacement part
US-BLSP002 - Hot
CARTRIDGE
Replacement part
US-BLSP002 - Cold
l
Shut off
the
water heating system then, with
the
main water
supply
turned off
, open the lowest hot and cold faucets and allow
to drain until supply pipes are empty.
l
Identify all components before fitting.
l
Use the rubber seal, horseshoe plate and retaining nut provided
to install the faucet to the
counter/
basin as shown below.
l
Connect the hot and cold water supplies.
ATTENTION
:
Check all new connections for leaks.
l
Turn on the main water supply, close all faucets except for the new
installed faucet and as the system refills, check for leaks.
l
Once satisfied there are no leaks, switch on the heating system.
1
Installation
Rinse away any traces of soap and gently dry with a clean, soft cloth after each use. Rinse completely with water and dry any overspray.
This will maintain the finish and avoid water spotting.
To remove mineral deposits, use a 50/50 solution of white vinegar and water. Do not allow the solution to soak on the product.
Simichrome Polish® contains a protective film to enhance maintenance and is helpful in preventing water spot buildup. Follow instructions to
ensure optimum results.
Never use an abrasive material such as a brush or scouring pad to clean the surface. The use of abrasive cleaners, cleansers or disinfectants will
alter the surface finish and void the warranty.
Do not allow certain materials such as toothpaste, cologne, shaving cream, nail polish remover, vinegar, wine, drain and glass cleaners to
remain on the surface. Prolonged contact will alter surface finishes and void the warranty.
We DO NOT recommend using any household cleaners as many can cause damage to the finish.
Please see the website for care instructions for specific finishes.
3
Cleaning Instructions
2
Parts list