Installation Instructions
2
"
1
"
G
1
/
2
”
1
-3/8"
9
-1/4"
8
-1/8"
Adjustable
wrench
Channel
locks
Plumbers’ putty
or caulking
Flat head
screwdriver
Cross head
screwdriver
Hexagonal
key
2
-1/2"
1
-1/4"
G
1
/
2
”
1
-1/4"
13”
11
-3/4"
Arcade
Air Boost Rain Head
s
US-ARCV17
US-ARCV60
Introduction
Installation notes
This shower
head
is suitable for use with all water systems up to a
maximum operating pressure of 72 psi, beyond which pressure
-
reducing valves must be
installed
. The minimum water pressure
requirement is 3 psi.
The shower
head
has been fully inspected throughout the production
process and only leaves our factory after a 15
-step
QC process.
Carefully remove the shower
head
from the box and check that all
parts have been supplied.
Before beginning installation
,
please check for any damage that may
have occurred during transport.
Note: Damage claims cannot be
made during or after installation.
Improper installation shall result in loss of warranty in case of damage
caused by impacts or rubbing against rough surfaces.
IMPORTANT: Please read these instructions carefully before
begin
ning
and retain for future reference.
We do not accept responsibility for any problems that may occur
through incorrect installation.
Dimensions
Tools required
The installation must comply with all plumbing codes including local
codes and be installed by a licensed plumbing contractor.
IMPORTANT!
Before installing a new shower
head
it is essential that
the supply lines are thoroughly flushed in order to remove any
remaining
debris
, solder or other impurities. Failure to carry out
this simple procedure can cause problems or damage to the
function
of the shower
head
.
Installing shut-off valves on incoming supply lines is recommended
for ease of maintenance.
Turn off the main water supply before connecting to any existing
pipe work or doing any maintenance.
WARNING! Please check for any hidden pipes and cables, electric
or otherwise before drilling holes in a wall or floor.
9”
s
hower
head
1
3
”
s
hower
head
