CCpilot X1400
Product revision: 1.0
Technical manual
2022-12-20
www.crosscontrol.com
14
6.
Connectors
All connectors are accessible from the rear side of the unit. The connectors are marked with an X
and a number as well as a short descriptive text, e.g. X6 USB 2.0.
In order to give the CCpilot X1400 its high environmental classification, the unit is equipped with
DIN M12 connectors. CrossControl can provide adapter cables which convert from DIN M12 to
other connector standards.
Use caution and avoid plugging/unplugging of connectors when the computer is on.
Always replace a damaged cable. If the pins become bent or damaged they may not function
correctly, and the on-board computer or other equipment can be damaged.
6.1.
Connector layout
Notice that the connector descriptions are those which are located on the unit, not those that the
attached cables shall have in order to mate with them.
X1 - Power Supply Connector
Pin
#
Default
signal
Comments
DIN M12 x 1
Male, 5-pole
L-coded
1
VIN
Main Power Input
2
GND
GND Supply
3
ON/OFF
ON/OFF Input Signal
4
VIN
Main Power Input
FE (5)
GND
GND Supply
X2, X3 - CAN Connector
Pin
#
Default
signal
Comments
DIN M12 x 1
Female, 5-pole
A-coded
Rotation 180°
1
CAN Shield
Connected to chassis ground
2
V+
Can be implemented on request
3
CAN_GND
4
CANH
5
CANL
Housing
CAN Shield
X4, X5 - Ethernet Connector
Pin
#
Default
signal
Comments
DIN M12 x 1
Female, 4-pole
D-coded
Rotation 180°
1
Tx+
2
Rx+
3
Tx-
4
Rx-
Housing
Shield
