Cross Technologies 2015, Инструкция по эксплуатации

Страница: 10 / 21

2.2 Rear Panel Input/Output Signals - Figure 2.2 shows the input and output connectors on the rear panel.
AC
GND
J18
10 MHZ REF
OUTPUT
J10
AND
MONITOR
CONTROL
J10 - MONITOR AND CONTROL
DB9 female connector. See Table 2.1.
RF OUT
J4 J5 J3
10 MHZ
IF IN
EXT REF
J3 - 10 MHz EXT REF INPUT (Option -E)
10 MHz external reference input, 0 ± 3 dBm,
75 ohms, BNC female connector.
J5 - RF OUT
2000-2500 MHz output, -20 to 0 dBm out,
See Table 2.2. J4 - IF IN
140 MHz input,
-10 to -40 dBm in,
See Table 2.2.
INPUT
J18 - 10 MHz REF OUTPUT (option -E)
10 MHz reference output.
75
BNC female connector.
1 5 2 3 4
6 7 8 9
FIGURE 2.2 2015-26 Rear Panel I/Os
TABLE 2.1 JJ10 J10 Pinouts (RS-232C/422/485*)
Pin Function
1 Rx-
2 Rx+ (RS-232C)
3 Tx+ (RS-232C)
4 Tx-
5 GND
6 Alarm Relay: Common
7 Alarm Relay: Normally Open
8 Not Used
9 Alarm Relay: Normally Closed
*Remote Serial Interface
Interface: DB-9 Male
Protocol: RS-232C (RS-232C/422/485 option Q), 9600 baud rate, no parity, 8 data bits, 1 start
bit, 1 stop bit.
TABLE 2.2 IIF/RF I F/RF Connector Optionns Optio ns
Option IF RF
STD BNC, 75 BNC, 50
-B BNC, 75 BNC, 75
-D BNC, 50 BNC, 50
-N BNC, 75 Type N, 50
-M BNC, 50 Type N, 50
2015-26 Manual, Rev. 0 Page 10 12/09/10