2.2 Rear Panel Input/Output Connectors
The input and output connectors on the rear panel are shown in Figure 2.1.
CAUTION! IF A FUSE IS INSTALLED IN THE FUSE F1 HOLDER, +22 VDC WILL APPEAR ON THE
SPLITTER INPUT CONNECTOR (J17) CENTER PIN.
AC A INPUT
*
100-240
±
10% VAC,
47-63 HZ Uses 2 amp
Slow Blo, 5mm fuse
J17 - SPLITTER INPUT
Type F (female) 75
Ω
.
See Table 2.0 for other
connector options.
J16,J15,J14,J13,J12,J11,J10,J9 - SPLITTER OUTPUTS
Type F (female) 75
Ω
. Terminate when not used. See
Table 2.0 for other connector options.
AC B INPUT
100-240
±
10% VAC,
47-63 HZ Uses 2 amp
Slow Blo, 5mm fuse
AC A
AC B
GND
JI
J2
J3
J4
J5
J6
J7
J8
J9
J10
J11
J12
J17
J13
J14
J15
J16
IN
FUSE F1
SPLITTER
J8,J7,J6,J5,J4,J3,J2,J1 - SPLITTER OUTPUTS
Type F (female) 75
Ω
. Terminate when not used. See
Table 2.0 for other connector options.
FIGURE 2.1 1584-116 REAR PANEL
TABLE 2.0 RRF
2.0
RF Connector Options
Option
RF Connectors
STD
Type F, 75
Ω
-B
BNC, 75
Ω
-D
BNC, 50
Ω
2.3 Front Panel Monitors and Indicators
Figure 2.2 shows the front panel monitors and indicators.
TP1 - +DC TEST POINT
Used to measure the LNB voltage.
+22VDC typ.
DS5 - POWER LED A
Lights green when DC
voltage is present from AC A
power supply.
TP5 - GND TEST POINT
Used to measure the LNB voltage.
DS1 - LNB VOLTAGE LED
Lights Green when LNB voltage is present
on the Splitter input (J17) center pin.
A
POWER
B
LNB VOLTAGE
ON
GND +DC
MODEL 1584
SPLITTER
C
ROSS
T
ECHNOLOGIES INC.
FIGURE 2.2 1584-116 FRONT PANEL
*NOTE: Model 1584-116S has a single non-redundant, switching power supply.
1584-116 Manual Rev. G
Page 6
04/23/13
