Specification
Frequency Range
: FM 87.5 - 108.5 mHz
: AM 525 - 1710 kHz
Power Source
: AC 120V ~ 60 Hz
Power Consumption : 130 W
Antennas
: External 300 Ohm connection for AM/FM antenna
Speaker
: 6 ½” Dynamic type x 2
: 2 ½” Tweeter type x 2
* DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
.
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER -
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lighting flash with arrowhead symbol, within an equilateral triangle,
is intended to alert user to the presence of uninsulated "dangerous
voltage" within the product's enclosure that may be of sufficient magnitude
to constitute risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended
to alert user to the presence of important operating and
maintenance (servicing) instruction in the literature accompanying
the appliance.
NOTE: When you unpack your Jukebox you will find the CD magazine, remote control, the external antenna
wire, and catalog with warranty information enclosed. The antenna will be in a small plastic bag packed
next to the box with the CD magazine. It consists of a small black wire about 3 feet long. One end has a
metal connector. Insert this end into the 75 ohm antenna plug on the back of the Jukebox.
Troubleshooting Tips
•
No Sound: Check the Internal/External speaker switch on the back of the Jukebox and make sure it is set to
the INT. (Internal Speakers) position. Also check to see if the MUTE function is enabled.
•
Bubble Tubes not bubbling: It can take the heaters 10 to 15 minutes to heat the liquid enough for bubble
action to begin. If they have not started after this amount of time, very lightly tap the bottom of the tubes with
your fingernail to start the tubes bubbling.
•
Poor reception or no aparent sound with radio in AM or FM mode: The CR12-10 Jukebox uses an external
antenna. If the antenna is not connected to the 75 ohm plug on the back of the Jukebox, reception of both AM
and FM stations will be poor. In most instances with no antenna connected, it will seem as if the sound is not
working.
•
AM Radio and Buble Tubes: Due to interference caused by the Neon Lights, the AM Radio will only function
properly with the lights turned off.
•
CD Player malfunctions with one of the following problems:
The loaded disc will not play or the system changes to the next disc before the selected disc has a chance to
play. The same disc is played over and over again. These symptoms usually occur when there are burrs on the
center hole or the outside circumference of the disc. Small burrs can prevent the disc from loading properly. In
most cases you can use the side of a ball point pen or similar object to smooth the burrs.
Warning: Although there is a protective film being marketed as a CD accessory, use of these products
will result in malfunctions and should absolutely be avoided.
WARNING:
To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.
CAUTION:
Use of controls or adjustments or performance of procedures other than those specified may result
in hazardous radiation exposure.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
•
To locate your saved stations: Select the band by pressing MOD to toggle between CD Player / Radio. Press
BND to scroll through band selections FM 1 through AM 2. If you have stations saved at the FM 1 display, use
button numbers 1 through 6 to find stored channels in that section. Press BND to move to FM 2, then use buttons
1 through 6 to scroll through the saved channels in the FM 2 location. Repeat for each additional band mode.
•
To change tracks on the current playing disc: Press the Skip button to move up to the next track
or the Tune button to move back to the previous track.
•
To change to a different disc: Press the D.UP button to move up to the next disc or the D.Down
button to move down to the next available disc.
•
To repeat the current play track: press the RPT button.
•
To hear the beginning of each track: Press the SCN button to hear at least the first 10 seconds of
each track on the selected disc.
•
Random Play. To let the system randomly select and play tracks from the selected disc, press the
RND button.
•
The remote will control the following functions on the CR12-10:
•
Power: Press to turn the Jukebox On / Off.
•
Mod: the mode button selects between the CD Player or AM/FM Radio mode.
•
Mute: Press mute to silence the sound from either the CD Player or AM/FM Radio.
Press again to restore sound to previous level.
•
Lou: Press the loud button to reinforce the bass level. This feature works especially
well when listening at low volume level
•
Band: The band button is used to navigate through and select the band options,
FM 1, FM2, FM3, AM 1 or AM 2. Press repeatedly to move through the selections.
•
Skip Back: Press to skip back to the previous track in CD Player mode or to tune
down in frequency in the AM/FM radio mode.Press and hold the skip back button
for at least 1 second to seek back to the first station with a strong signal. However
the seek will miss many of the weaker stations. Repeatedly press the Tune or Skip
button to find the most stations.
•
Skip Forward: Press to skip forward to the next track in CD Player mode or to tune up
in frequency in the AM/FM radio mode. Press and hold the skip forward button for at least
1 second to seek forward to the first station with a strong signal. However the seek will
miss many of the weaker stations. Repeatedly press the Tune or Skip button to find the
most stations.
•
Sel: With the system in either CD Player or AM/FM radio mode, repeatedly press the
select button to choose mode of volume, bass, treble, or balance. Then use the volume
up or volume down button to increase or decrease the level of selected mode.
•
Volume Up and Volume Down Use the select button to choose volume, bass, treble,
or speaker balance. Then use the volume up / volume down button to control level of
each selected mode.
Using the Remote to save your favorite radio stations to Memory:
•
You may use the remote to save your favorite stations to memory so you can quickly return to them at a later
time. You will notice the buttons on the lower part of the control are numbered 1 through 6. The Memory function
lets you save up to 6 of your favorite stations in each "band" mode. A total of 30 stations can be stored in the
memory.
•
Use the MOD button to select radio mode. Then press BND to select one of the available bands. For this example
we will choose FM 1.
•
Next, use the skip forward or skip back button to scan through the stations and choose your first one to save.
When you have selected a station, press number 1 on the remote and hold it for at least 2 seconds.You will hear
a "beep" when you press. Continue to hold and in about 2 seconds you will hear a second beep. This confirms
that your station has been saved. Now, if you will notice in the LCD display you will see that you are in section
FM 1, your selected station frequency is displayed in the center and on the right side of the LCD your first saved
selection is shown as CH 1. To add a second preset station, use the skip forward or skip back button to locate
the next station you want to save, then press and hold button number 2 on the remote keypad. You may add up
to 6 stations in the FM 1 section. To save more stations, repetedly press the BND button to advance to FM 2,
FM 3, AM 1 etc. and repeat the above steps to locate and save more stations. You may save up to 6 stations in
each "band".
REMOTE OPERATION
Using The Remote
Before using the remote you must install 2 AAA sized batteries in it. Remove the cover from the back of
remote and install batteries with the + and - ends matching the diagram in the bottom of the battery tray.
•
D.UP: In CD Player mode, press to move up to the next disc.
•
D.DN: In CD Player mode, press to move back to the previous disc.
•
RPT: In CD Player mode, press to repeat the currently playing track. Press again to cancel action.
•
SCN: In CD Player mode, press the scan button to hear at least the first 10 seconds of each track. Press
again to cancel action.
•
RND: In CD Player mode, press the random button to let the system randomly select and play tracks from
the selected disc. Press again to cancel action.
1
6
