3 of 5
Step1: Place tabletop upside down on a flat, non-abrasive surface. Attach table leg to
tabletop using 1/4"x 15mm bolt (1) and 1/4" (2) washer as shown in (
Figure 1
).
Add 1/4" nut (4) to the end of bolt. Tighten a few revolutions only. Do not tighten
completely at this time as some adjustments may be necessary to the alignment
of the table legs. Repeat for remaining two legs.
1
6
4
Figure 1
2
A
B
Step2: Insert table leg connector ( C) in the center of the three legs as shown in Figure 2.
Secure by inserting two ST4.2 x 33mm bolt (5) through the two holes in the center of
the leg and into the leg connector as shown in (
Figure 3)
. Tighten a few revolutions
only. Do not tighten completely. Repeat for remaining two legs.
C
Figure 2
3
7