18
AUTOMATIC ICE & WATER DISPENSER
PURESOURCE 3
TM
ICE AND WATER FRONT
FILTER
(SOME MODELS)
LOCATING THE FILTER
Your refrigerator is equipped with a water filtering system. The
water filter system filters all dispensed drinking water, as well as
the water used to produce ice.
WATER FILTER
The water filter is located at the top right side of the fresh food
compartment.
Do not use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.
Systems certified for cyst reduction may be used on disinfected
waters that may contain filterable cysts.
TEST & CERTIFICATION RESULTS:
• Rated Capacity - 200 gallons/757 liters for
PureSource 3
TM
ice and water filter
• Rated service flow - .50 gallons per minute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per square inch
• Recommended Minimum Operating Pressure: 30 pounds per
square inch
TO REPLACE YOUR PURESOURCE 3
TM
WATER
FILTER:
It is not necessary to turn the water supply off to change the filter. Be
ready to wipe up any small amounts of water released during the filter
replacement.
1 Turn
Off the ice maker power switch.
2 Remove the filter by pushing on the end/face of the filter.
3 Slide the old water filter cartridge straight out of the housing
and discard it.
4 Unpackage the new filter cartridge. Using the alignment guide,
slide it gently into the filter housing until it stops against the
snap-in connector at the back of the housing.
5 Push firmly until the cartridge snaps into place (you
should hear a click as the cartridge engages the snap-in
connector).
6 Press a drinking glass against the water dispenser while
checking for any leaks at the filter housing. Any spurts and
sputters that occur as the system purges air out of the
dispenser system are normal.
7
After filling one glass of water, continue flushing the system for
about
four (4) minutes.
8 Turn
On the ice maker.
9 Press and hold the Water Filter button on the Ice & Water
Dispenser control panel for three seconds. When the display
changes from “
Red” to “Green,” the status has been reset.
ORDERING REPLACEMENT FILTERS
To order your replacement filters, please visit our online store at
www.frigidaire.com/store, by calling toll-free at 877-808-4195,
or by visiting the dealer where you purchased your refrigerator.
Electrolux recommends that you order extra filters when you
first install your refrigerator, and that you replace your filters at
least once every six months.
Here are the product numbers to request when ordering:
PureSource 3
TM
Water Filter
Part #
WF3CB
REPLACING THE WATER FILTER
In general, you should change the water filter every six months
to ensure the highest possible water quality.
Water Filter
Status on the user interface prompts you to replace the filter
after a standard amount of water (200 gallons/757 liters for
PureSource 3
TM
)
has flowed through the system.
If your refrigerator has not been used for a period of time
(during moving for example), change the filter before reinstalling
the refrigerator.
The
PureSource 3
TM
ice and water filter system
is tested and certified to NSF/ANSI Standards 42
and 53 for the reduction of claims specified on the
performance data sheet.
MORE ABOUT YOUR ADVANCED WATER
FILTER
