Copyright® 2014 The Crosby Group LLC
All Rights Reserved
2
INTRODUCTION
Crosby CLAMP-CO beam clamps are below the hook lifting devices designed to provide
an efficient method for handling wide flange beam sections and plate girders. Always
follow the stated limitations discussed in this manual and shown on the product’s Warning
and Operating Procedure Labels.
Crosby Clamp-Co beam clamps have been safely and successfully used in the field for
over 30 years. Your safe use of our products depends on you. Please be responsible and
make sure all people using our products follow these simple rules:
1.
Beam Clamps are used to the purpose for which they were designed.
2. They are not loaded beyond their Working Load Limit.
3. They are properly lubricated and maintained.
4. They are inspected regularly and tested in accordance with the relevant statutory
regulations.
5. They are used by competent persons trained in their use.
6. Beam Clamps are returned to the factory every two years for inspection,
retesting and recertification.
As with all mechanical handling equipment, there is a degree of hazard involved with the
use of these beam clamps if not properly used. Failure to follow the appropriate safety
precautions and operating instructions may cause the load to slip or fall, and may result in
serious injury, death, or property damage.
GENERAL INFORMATION
Each Crosby Clamp-Co beam clamp is proof tested and certified prior to shipping. Beam
Clamps are proof tested to 200% of Working Load Limit.
Follow all requirements of laws, rules, and regulations applicable in your country pertaining
to lifting operations, ensuring all maintenance, testing, inspection and operator training
requirements are strictly adhered to.
