Cromtech TG6500VE, Руководство по эксплуатации

Страница: 18 / 32

CONNECT TO ELECTRICAL DEVICES
! WARNING: This generator is fitted with an RCD Circuit
Breaker. ALWAYS test RCD switch before every use.
! CAUTION: Inspect power cords for damage before
using. There is a hazard of electrical shock from crushing,
cutting or heat damage.
1. Allow the engine to stabilise and warm up for a few
minutes after starting.
2. Make sure the electrical devices are in their ‘OFF’
position and the load current is not higher than the
maximum withstanding current of single socket.
MAXIMUM CAPACITY
! WARNING: DO NOT overload the generator. Exceeding
the capacity of generator can damage the generator and/or
electrical devices connected to it.
• You must make sure your generator can supply enough
rated(running) and surge (starting) watts for the
electrical devices you will power at the same time.
Follow these simple steps to calculate the running and
starting watts necessary for your purposes.
1. Select the electrical devices you will be powering at the
same time.
2. Calculate that the total amount of power you need
to run all devices is less than the rated output of the
generator. You may need to check the items rated
(running) watts in their manuals.
3. Identify how many surge (starting) watts you may need.
Surge wattage is the short burst of power needed to
start electric motor-driven tools or appliances such as a
circular saw or refrigerator.
Pg. 18