Visit us at
crlaurence.com
for international toll free information 5
A
C.R. LAURENCE CO., INC.
OPERATION
Hold the tool firmly with both hands. Turn the tool on and wait until it attains your desired speed.
Gently apply the tool to the workpiece surface and move the tool forward and back. Press the belt
only lightly on the workpiece. Excessive pressure may damage the belt and shorten tool life.
CAUTION
:
• Secure the workpiece with clamps, etc. if there is any possibility of it moving during the work operation.
• The tool should not already be in contact with the workpiece surface when you turn the tool on or
off. Otherwise a poor sanding finish, damage to the belt or loss of control of the tool may result.
• When working with the tool, be very careful to avoid any contact of the tool and belt with any part
of your body or anything near you.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
Replacing Carbon Brushes
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only
identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
Dust Extraction
Open the nozzle cap. Connect the
hose of a vacuum cleaner/dust
collecter to the nozzle.
CAUTION
:
Always close the nozzle cap when the hose of a vacuum cleaner/dust collector is not connected to
the nozzle. Never insert your finger into the nozzle.
Nozzle Cap
Nozzle
Limit Mark
Brush
Holder
Cap
Screwdriver
