3.5-leaf barndoor set up
3.6 Electrical connection
1) Cable the provided mains plug with a supply cable 4x2.5 mm
2
minimum (ground);
2) Connect the lantern to a mains supply of 380V - 50/60Hz.
3) Ensure that the mains cable is connected to earth;
the safety thermoswitch must have the following characteristics:
rated for (In) 16A - sensitivity (Id) 0,03 A.
4) KOLORADO
®
4000 is provided with power factor correction system.
4.0 DISPLAY AND CONTROL PANEL USE
The led colour indicates the projector mode.
The green led indicates the operating mode.
The red light indicates the setting or the zapping mode.
When the projector is in the operating mode the display indicates the projector DMX addressing
number, which is 001 when the unit leaves the factory. In order to change the DMX addressing
number push (SELECT) then (-) or (+). When you find the desired number push (ENTER).
Push (SELECT) when you want to view or zap an option. To memorise it push (ENTER).
If options are not entered within 15 seconds the projector returns to the operating mode.
13
pict.12
R
S
T
KOLORADO
4000
L 1
L 2
L 2
L 1
KOLORADO
4000
KOLORADO
4000
L 1
L 2
1
2
3
L 2
L 1
L 3
Please note:The Kolorado 4000W operate with 380V 2- phase voltage.
To connect 2 or more projectors on the same 3-phase line, follow the
connection scheme shown above.
Connect the plug supplied to L1 and L2 +
ground described in the layout
Disconnected
380 V
380V
3-Phase
G R EEN LED
R ED LED
Flashing red led -
D M X SETTIN G
R ed led - O PTIO N S
SETTIN G
G reen led - D M X
SIG N AL
Flashing green led -
N O D M X SIG N AL
-
Select
+
Enter
Flashing green led -
NO DMX SIGNAL
Green led - DMX
SIGNAL
Flashing red led -
DMX SETTING
Red led - OPTIONS
SETTING
ORDER DIRECTLY TODAY AT:
www.BulbAmerica.com
or CALL TOLL FREE 888-505-2111
