Critical Environment Technologies CET-RDM, Руководство по эксплуатации, Страница: 15 / 32

© 2021 All rights reserved. Data subject to change without notice. 15
Rev. B | 2021.12 RDM - Operation Manual
The RDM requires no assembly and virtually no maintenance. There are no
serviceable elements or replaceable components.
5.2 Protection Against Electrical Risks
The RDM Remote Display is designed to be powered by the FCS. Disconnect
all power to all network devices before servicing. There may be multiple
power sources. Power supply may have a building installed circuit breaker /
switch that is suitably located and easy to access when servicing is required.
Appropriate markings should be visible at the circuit breaker / switch that is
supplying power to controller.
This device may interfere with pacemakers. Modern pacemakers have built-in
features to protect them from most types of interference produced by other
electrical devices you might encounter in your daily routine. If you a have a
pacemaker, follow your healthcare provider’s instructions about being around
this type of equipment.
5.3 Protection Against Mechanical Risks
The door of the enclosure can be removed if absolutely necessary to facilitate
installation of the base but it is not recommended on this version. Extreme care
and caution must be exercised when removing the door to avoid damaging
the hinges. The door should only be removed when absolutely required. Any
damage occurring from door removal procedure will not be covered under
warranty.
Simply grasp the door with one hand, being careful not to make contact with
any of the internal components (circuit board), grasp the base with your other
hand. Tug on the base and pull straight apart. DO NOT TWIST. The section of
the hinges located on the base should “snap” apart from the part of the hinges
located on the door.