19
MAiNtENANcE
DISpLAY CoDES
CoDES CAuSES
SoLutIonS
Err1
¬ Washer door is not properly shut .
_ Shut the door properly
Err2
¬ Drainage error . Water is not emptied
within 4 minutes .
_ Clean the filter and check the drain hose for blockage .
Remove filter in case any water remains in the unit .
Err3
¬ Temperature sensor error .
_ Please contact the Service Center .
Err4
¬ Heater error or laundry overload . The set
temperature is not reached within specified
time . (Appears at the end of a cycle) .
_ Reduce load and start washing again .
_ Please contact the Service Center .
Err5
¬ Water level not met within 8 minutes .
_ Check the tap and the water pressure .
Err6
¬ Dehumidification/heating error .
_ Please contact the Service Center .
Err7
¬ Motor overheat error .
_ Please contact the Service Center .
Err8
¬ Water overflow .
_ Please contact the Service Center .
Err9
¬ Error of the dryer temperature sensor .
_ Please contact the Service Center .
Er10
¬ Error of the water level sensor .
_ Please contact the Service Center .
Er12
¬ Error of the dryer water level sensor .
_ Check whether clothes are dry or not and whether there is
water still in the drum . If so allow excess humidity to
escape from the appliance and try the drying cycle again .
Er13
¬ Dryer heater error .
_ Please contact the Service Center .
Unb
¬ Laundry is unevenly distributed .
_ Redistribute laundry to balance the drum .
EUAr
¬ Communication error .
_ Please contact the Service Center .
1:16
¬ Status information: remaining program time is 1 hour and 16 minutes .
0:01
¬ Status information: remaining program time is 1 minute .
60°C
¬ Status information: Wash temperature is 60°C .
--°C
¬ No heat (cold wash) .
0
¬ No spin .
800
¬ Status information: Spin speed 800 rpm .
L--1
¬ Manually selected code when laundry weight is less than 1kg .
L--A
¬ Manually selected code when drum is nearly full .
End
¬ Program is finished .
DiSpLAY cODES AND SpEciAL FUNctiONS
¬ control panel lock function:
Press the "Delay" and the "Start/Pause" buttons simultaneously for 3 seconds after
starting a program . It can no longer be changed by operating buttons or knobs . The washing machine emits an audible
signal while the control panel is locked . To unlock press the "Delay" and "Start/Pause" buttons again for 3 seconds .
¬ power-off memory function:
In case of abrupt power failure or the need to cut off the power during a program
cycle, the present settings will be saved and the preset operation will resume when the power is on again .
¬
to cancel a program or select a new program and options during the wash cycles:
Press the "Start/Pause" button, then switch off the power and the program is automatically cancelled . Turn the program selector again to choose another program .
