CrimeStopper CS-2002, Инструкция по установке и эксплуатации

Страница: 13 / 20

OPERATING INSTRUCTIONS
ACTIVE ARMING
To arm the alarm and lock the doors, press the #1 (Lock Symbol) button on the transmitter. You will hear a single
siren chirp and the lights will flash once. The system will arm, the doors will lock and the starter will be disabled if these
optional features are installed. The red LED in the vehicle will start flashing after 15 seconds. After a short delay to
allow vehicle and electronics to stabilize the system will be completely armed.
ALARM TRIGGERING
If there is an intrusion into the vehicle or hard impact to the body will sound the alarm and flash the lights for 45
seconds. After 45 seconds the system will automatically shut off and re-arm to continue to protect the vehicle. If a
door is left open, the unit will cycle a second time and still continue to protect the other un-tampered zones.
DISARMING
To disarm the alarm and unlock the doors, press the #2 (Unlock Symbol) button on the transmitter. You will hear 2
siren chirps and the lights will flash twice. The dome light turns on and the dash LED stops flashing.
TRUNK/HATCH POP (REMOTE AUX. OUTPUT 1, OPTIONAL)
To pop the trunk (if optional feature is installed), press Button #3 (Trunk Symbol) on the transmitter for at least 1 ½
seconds.
If the system is armed, pressing Button #3 may or may not trip the alarm system when opening the trunk
depending on programming option (10). See page 9.
REMOTE PANIC PROTECTION
To sound the alarm upon command (panic), press and hold the Button #4 (Panic) for at least 2 seconds until the siren
sounds. Press Button #2 (Unlock) to reset panic mode.
PRE-WARNING SHOCK PROTECTION & SENSOR ADJUSTMENT
If a low-level shock to the vehicle is detected, pre-warning protection will activate sounding 6 quick siren chirps and 1
light flash. If a hard impact is detected the shock sensor should trip the alarm system. Once it is mounted, adjust the
sensor as needed by turning the adjustment screw clockwise to increase or counter-clockwise to decrease the
sensitivity. The sensor is also equipped with 2 small indicator lights to ease the adjustment process. Green light =
Pre-warning disturbance (6 siren chirps). Red light = A full alarm trip.
ARMING WITHOUT SHOCK SENSOR PROTECTION
To arm the alarm without Shock sensor protection, press button #1 as normal then press Button #4 (Panic) within 2
seconds. You will hear an extra siren chirp indicating shock sensor bypass.
SILENT ARM/DISARM THROUGH REMOTE (BUTTON #3)
This system can be armed and disarmed without siren chirps on an “as needed” basis. Press and quickly release
Button #3 (TRUNK) to Arm and Disarm system without chirps. NOTE: If Button #3 is pressed too long, then trunk pop
may activate (If optional Trunk-pop feature is connected to the system).