PROGRAMMABLE OPTIONS
13. Horn Chirp Confirmation with Double Lock/Unlock Press (When Optional Horn Output installed):
This option allows the system to chirp the vehicle horn for Lock/Unlock confirmation when the Lock or Unlock Button on
the remote is pressed a 2nd time within 3 seconds. The horn output must be connected to use this feature.
14. Unlock With Trunk Pop or Trunk Pop Only:
This option controls whether the system will provide an Unlock/Disarm pulse when the Trunk release is activated from
the remote control. This may be required to prevent unnecessary triggering of a factory alarm on some vehicles.
15. Timed Crank Mode or Tach Monitor:
This option controls whether the system uses a tach wire to control the starter or uses a pre-set starter cranking
time.
16. Pre-Set Starter Cranking Time: (Requires Option #15 to be set to “Timed Crank”)
This option controls the starter output cranking time. Choices are 0.5, 0.75, 1, or 1.5 seconds.
17. Diesel Glow Plug Delay:
This option controls the system’s Diesel vehicle interface. Using this option you can control whether the unit monitors
the vehicle’s glow plug circuit using the Pink input wire (Default), or you may select a specific delay time before cranking.
This option is helpful if you are unable to locate a glow plug signal. Just select a delay time and do not connect the Pink
Glow Plug wire. Selections: 10, 20, 30 seconds, or Monitor Pink Wire (Default).
18. Remote Start Run Time:
This option controls the engine run time for remote start. Use the buttons on the remote control set a choice of 12, 24,
36, or 48 minutes. The default setting is 24 minutes.
19. Smart Tachless Voltage Adjustment:
This option controls the voltage reference point when using smart Tachless mode. Pressing the Lock or Unlock buttons
on the remote raises or lowers the reference level in 1% increments from 80%-%100. Button #3 resets the unit to the
factory default reference point of 90%. The default 90% setting works for most vehicles. See page 12 for additional
Smart Tachless mode information.
20. Option Reset:
This option allows you to restore all programmable options to factory default values. Go to the 20
th
option and press
the Unlock Button #2 on the remote. The unit will flash the lights 2 time and all values will be reset to factory
original settings. Default values are marked with asterisks in the chart on pages 16-17.
