Millennium FX Car Monitor
CM-3000/CM-3001
**Addendum to Instructions**
POLARITY LEARNING:
The Millennium FX Car Monitor has polarity-learning trigger inputs. (DOOR/HOOD/TRUNK)
The system learns (reads) polarity 30 seconds after 12V power up. Once you initially
power the unit up, be sure to CLOSE ALL TRIGGER ZONES and be sure SHOCK SENSOR
IS NOT ACTIVE. WAIT AT LEAST 30 SECONDS FOR THE CM3000/3001 TO READ
TRIGGER ZONE POLARITIES BEFORE TESTING THE SYSTEM.
If any trigger zones are
open when it reads them, they will operate in the opposite way. EXAMPLE: If the unit is
installed on a vehicle with negative door triggers and the system learns the door zone with a
door open, it will act like a positive door trigger system and alert the pager on door closing
instead of door opening. This applies to trigger Zones: Door, Trunk, and Ignition On.
AFTERMARKET HOOD / TRUNK PIN (STAND ALONE INSTALL):
If you are installing Car Monitor by itself [no host alarm] with an Aftermarket Grounding pin
switch for the BLUE trunk wire input or the BROWN hood wire input, you must add a 10K pull-
up resistor to a +12-Volt lead. This will allow the Car Monitor to see 12 Volts on the trigger wire
when closed so the polarity will be Negative for that zone. See diagram below.
10 K
AFTERMARKET HOOD
OR TRUNK PIN SWITCH
+12 VOLTS
BLUE
CM-3000/3001
