RML-O-S
9 SEPT 2019
6
4.
Turn the
HEAT
Control to it’s highest position
5.
When Floss starts to flow out of the head, lower the
HEAT
setting until the desired
consistency of floss is produced.
6.
The leather ‘floaters’ on the top of the spinner head create a draft of air, which controls
where the cotton candy floss lies in the bowl. Twisting them up or down causes the candy
to lie higher or lower in the bowl. Once adjusted the should not require much attention.
NOTE: Since atmospheric conditions, such as humidity and air temperature affect the production
of cotton candy, it will be necessary for you to determine the correct operating heat setting.
After working with the machine for a short time, the proper setting is easy to determine.
Caution. Don’t attempt to touch the Spinner Head when it is turning and making
cotton Candy. The sugar is heated to 300 Deg Fahrenheit to make cotton candy and
can cause severe burns. Don’t attempt to pick up the sugar with you bare hands,
always use a Cotton Candy cone or stick.
7.
When Spinner head is empty and needs to be refilled repeat steps 1 through 5
3.
Shut Down.
1.
It is recommended that the Spinner Head be empty but is not essential.
2.
Turn the
HEAT
switch to THE ‘OFF’ (0) position.
3.
Wait thirty seconds for the head to cool down.
4.
Turn the
MOTOR
switch to the ‘OFF’ (0) position.
Always turn heat ‘OFF’ (0) first, and then turn the motor ‘OFF’ (0).
X.
SANITATION INSTRUCTION
Do not hand clean heated surfaces until they have been given sufficient time to cool.
Failure to do so may result in serious burns.
1.
Spinner Head
1.
Spinner head should be cleaned after daily or whenever operation will be suspended for an
extended period of time.
2.
Following the operating instructions run the machine until the Spinner Head is empty.
3.
With the motor and heat switches “ON” (I). Increase the HEAT control to maximum. Run
until Head begins to smoke.
4.
Turn motor switch to the “OFF” (0) position, and let spinner head stop spinning. Within 5
to 10 seconds you will see liquid sugar begin to ooze through the holes on the spinner
screen. Then turn motor switch to the “ON” (I) position. This will throw the sugar out of
the head
5.
Repeat steps (2 and 3) two or three times.
6.
After last cycle turn heat “OFF” (0), wait 30 seconds and turn motor “OFF” (0).