CMD25
6
3/02
B.
Power Supply
1. Check the nameplate to determine the required power supply.
Connect your popcorn popper only to the correct power source. Failure to do so may
result in personal injury or death and may damage your popper.
2. C. Cretors and Company recommends dedicated circuits for the caramalizer. The
CMD25 requires a dedicated circuit to avoid a voltage drop in the supply wiring. Check
your local electrical codes regarding fuse or circuit breaker requirements.
Make certain your popcorn machine is properly grounded. Failure to do so may result
in damage to your equipment or present a shock hazard.
C. Connecting your Machine to the Power Supply
1.
Make certain that the power supply circuit breakers are in the off position.
2.
If the supply cord is damaged, a Cretors approved service agent, or a qualified Cretors
employee must replace it in order to avoid a hazard.
VII. TROUBLE SHOOTING
In the case of improper operation, only a qualified person should perform the
following diagnostic checks, and, if necessary, corresponding adjustments and
repairs. Many of the following procedures may present an electrical shock hazard
and can cause serious injury or death.
Perform work only on de-energized circuits.
Failure to do so may lead to electrical shock
resulting in personal injury or death.
CAUTION!
Always turn off the HEAT switch
before adding the popped corn.
PROBLEM
POSSIBLE CAUSE
ACTION
Blade hub sticking.
Carmel hardening underneath the blade
hub causing it to stick and damaging the
motor drive.
After the last batch is
made and the mixer
has cooled, spray Non-
Stick into the mixer
and leave it until next
use.
Corn burning or too
chewy.
To raise or lower the temperature.
Push the up and down
buttons on the front of
the controller.
