16724-A/C/D/E
May 1, 2014
5
BEGIN SERIAL NO.12030745
VII. CONTROL SWITCHES
INDICATOR LIGHT
-Indicates heating element On/Off.
ROCKER SWITCH
-Turns blower motor and heating element On/Off.
DIGITAL CONTROL
-Displays and sets the temperature of the popping chamber.
VIII. OPERATING INSTRUCTIONS
Do not attempt to operate your Cretors popcorn machine until you have read and
understood this manual. Failure to do so may result in serious injury or death.
Do not attempt to operate your Cretors popcorn machine unless the installation
instructions have been strictly adhered to. Failure to do so may result in serious injury
or death.
Operate your Cretors popcorn machine only if it is in sanitary condition (See
SANITATION INSTRUCTIONS
). Failure to do so may result in illness to your
customers.
-
A. Turn the heat/motor switch to the “ON” position. The blower will start and the heating
element should begin producing heat. The indicator light will light up when the heating
element is on.
B.
Allow Popper to run a couple of minutes to stabilize the temperature. Once the digital
temperature display is around 285°F, the machine is ready for use. Once corn is added to the
chamber, the digital temperature display will begin to rise to popping temperature.
NOTE:
To change the set temperature, press the “set” button on the digital control, then use the
up or down arrows to increase or decrease the temperature to the desired point, then press
the “set” button again. The new temperature is now the set point. The range of accepted
values is 300°F - 480°F, with the factory installed set point being 460°F.
Avoid contact with the popper. Contact with a hot popping machine may result in
serious burns or scalds.
WARNING!
Allow for ample ventilation and air circulation space at the rear and
sides of the popper.
C.
Using the provided scoop, insert 12 ounces of unpopped corn into popping chamber. The
provided scoop holds 12 ounces of unpopped corn. This is the maximum amount that should
be placed into the chamber at one time.
CAUTION
: Use the provided scoop to push the door flap forward. This flap will
become extremely hot, and the provided scoop should be used to engage door flap in a
safe manner.
DO NOT TOUCH WITH YOUR HANDS!
