Crestron V-Panel V15, Руководство по эксплуатации, Страница: 30 / 36

V-Panel™ 12” and 15” HD Touch Screen Displays Crestron V12 & V15
Setup
Configuring the V-Panel
The V-Panel is configured from the setup menu using the DGE Digital Graphics
Engine (sold separately). Refer to the Operations Guide that came with your DGE.
Hardware Hookup
Ventilation The V12/15 should be used in a well-ventilated area.
To prevent overheating, do not operate this product in an area that exceeds the
environmental temperature range listed in the table of specifications.
Connect the Device Make the necessary connections as called out in the illustration that follows this
paragraph. Apply power after all connections have been made.
When making connections to the V12/15, use Crestron power supplies for Crestron
equipment.
Hardware Connections for the V12/15 (V15 Shown)
DM INPUT, D & M:
To DGE
DM OUT, D & M
24 A B G:
To DGE
DM OUT 24 A B G
USB:
To Mouse
or Keyboard
NOTE: For wiring between the V-Panel and DGE, use DM-CBL DigitalMedia
Cable. The maximum allowable cable length is 150 feet (46 meters). (Contact
Crestron if more than 150 feet is needed.)
NOTE: DMNet
®
wiring and Cresnet
®
wiring are not compatible.
Tilt Tension Adjustment
Tilt tension on the V12 and V15 is preset at the factory to allow the panel to be tilted
anywhere within its 35 degree tilt range and maintain its position during use. To
tighten tilt tension or to fix the panel at a given tilt position, use the three Allen
screws accessed through the hole in the touchpanel base, as shown in the following
illustration.
26
•
V-Panel™ 12” and 15” HD Touch Screen Displays: V12 & V15 Operations Guide – DOC. 6806D