DO
GUIDE
DOC. 7770A (2043445) 03.15
Specifications subject to change without notice.
Customize the Swivel Range
Aside from the permanently installed limiting screw attached to the swivel stop plate, two additional
08-32 x 1/8” limiting screws are included with the TSW-550/750/1050-SMK. These screws can be
used to set a custom range for swivel movement. Refer to the following illustrations for details.
DO
Use the Security Option
The touch screen can be locked to the TSW-550/750/1050-TTK using the two included 04-20 x 5/8”
screws. To use the security option, perform the following procedure:
1. Remove the two screws on the bottom of the unit that hold the metal bracket inside the
TSW-550/750/1050-TTK. Then, remove the metal bracket.
2. Place the touch screen face down on a clean, soft surface. Then, place tape on the back of the
touch screen as shown in the following illustration. The rear assembly must be held in place
during the rest of this procedure.
3. Remove the two 1/2” long screws from the rear assembly. Save these screws in case you decide
not to use the security option in the future.
4. Place the metal bracket from step 1 in position on the rear assembly of the touch screen, ensure
it is correctly oriented (right side up), and attach it using the two included 04-20 x 5/8” screws. To
prevent damage to threads, turn each screw counterclockwise until it engages the thread. Then,
tighten the screw to 3 in/lb.
5. Remove the tape attached in step 2.
6. With the touch screen still face down on the clean, soft surface, connect the LAN cable that
was routed through the TSW-550/750/1050-TTK to the touch screen and gently pull any excess
cable out through the rear of the TSW-550/750/1050-TTK to ensure the touch screen is seated
completely into the TSW-550/750/1050-TTK.
7. Place the TSW-550/750/1050-TTK in position over the rear of the touch screen. Then, reattach
the bottom of the TSW-550/750/1050-TTK using the two screws removed in step 1.
The specific patents that cover Crestron products are listed at
.
The product warranty can be found at
.
Crestron and the Crestron logo are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or other countries. Other trademarks, registered trademarks, and trade names may be used in this document to refer to either the entities claiming the marks and
names or their products. Crestron disclaims any proprietary interest in the marks and names of others. Crestron is not responsible for errors in typography or photography.
This document was written by the Technical Publications department at Crestron.
©2015 Crestron Electronics, Inc.
DO
Learn More
Visit the website for additional information
and the latest firmware updates.
Crestron Electronics
15 Volvo Drive, Rockleigh, NJ 07647
888.CRESTRON | www.crestron.com
Metal Bracket
Remove these screws
to release the metal bracket.
Apply tape to hold the
rear assembly in place.
Tab of Keyed Metal Washer
Where Swivel Motion Starts
Six Locations
for Additional
Limiting Screws
Permanent Limiting Screw
30º
90º
135º
Place the two limiting screws
to limit the amount of swivel
to the desired range.
Permanent Limiting
Screw
Remove these
screws.
Screws (2) 04-20 x 5/8”
TSW-550-TTK TSW-750-TTK
TSW-1050-TTK
TSW-550/750/
1050-SMK
