Crestron Touch The PC Driver, Руководство программиста

Страница: 15 / 32

Crestron Touch The PC Driver Software
Ethernet Communication #3 - Lectern Touchpanel with TPS-XVGAL
RGB
INPUT
PORT
RGB CABLE
PC
LECTERN TOUCHPANEL
(OR TPS-TPI) WITH
TPS-XVGAL
COM
PORT
CONTROL
SYSTEM
ETHERNET
WIRING
ETHERNET
ROUTER/HUB
COM
PORT
LAN
PORT
VGA
PORT
LAN
PORT
A
COMM. CABLE
B
E
D
NET (OR
CRESNET)
PORT
CRESNET WIRING
TO
NET
PORT
C
BKL T
MENU PROFESSIONAL CONTROL PROCESSOR
PRO
2
CRESTRO N
PORT CONNECTOR to CONNECTOR DEVICE PORT
A
1
VGA DB-15, male BNC-5, male Touchpanel RGB
B
2
COM DB-9, female DB-9, female Control System COM
C
3
NET 4-wire Cresnet 4-wire Cresnet Touchpanel NET
D
4
LAN RJ-45, 8-pin RJ-45, 8-pin Ethernet / Hub na
E
4
na RJ-45, 8-pin RJ-45, 8-pin Touchpanel LAN
1
2
3
4
Cresnet wiring is required for touchpanel operating power only.
Control System
Standard null modem serial cable.
DEVICE
FROM CABLING REQUIRED
Standard Ethernet cables (ref D &E).
Ethernet / Hub
PC
PC
Control System
A standard stranded VGA monitor cable with DB15F to BNC-5 adapter is required. Both are commercially
available.
REF
ETHERNET COMMUNICATION #3 - LECTERN TOUCHPANEL WITH TPS-XVGAL CARD
TO
2. Proceed to “Ethernet Setup” which follows.
Ethernet Setup
Ethernet devices that are addressed by the control system may have their IP IDs set
either in the SIMPL Windows program or through the Crestron Viewport using a
PC. Ultimately, each IP ID is converted into an actual IP address through an IP table
that exists inside the control system. The IP table is an internal list of information
that contains the IP IDs and associated IP addresses of all Ethernet devices in the
program. The IP table is accessed by the control system to identify and locate
Ethernet devices, for purposes of communication. Follow this procedure to add the
Touch The PC Driver, V2 software to the IP table of the touchpanel.
1. Using the Crestron Viewport, ( Remote | TCP/IP | Connect or Remote
| Remote Console | Connect ) establish communication with the
touchpanel.
2. As shown on the next page, use the ipt (IPTABLE) command to
display the current IP table for the CIP interface on the touchpanel.
Programmer’s Guide – DOC. 5916B Touch the PC Driver
•
11