Crestron TMK-4L, Руководство по установке

Страница: 10 / 16

Trim Ring Mount Kits Crestron TMK-4L & WMKT-4L
Touchpanel Mounting Using TMK-4L – Exploded View
DRYWALL
TRIM RING
(2013241)
TPS-4L
PMK-4L
TPS-4L
MOUNTING SCREWS (4) #04-40 X 2"
(2018793)
WMKT-4L Procedure
This section provides the necessary steps for the assembly and installation of the
WMKT-4L into a wall. Review the procedure and complete the steps in the order
provided. The only tools or materials required and not supplied are a drywall saw or
equivalent and a level.
CAUTION: Allow an air gap of at least 12 inches (30.48 cm) in the wall cavity
above and below the touchpanel for heat dissipation.
1. Locate an area on the wall that is free of miscellaneous wiring and studs.
2. Make a small hole near the middle of the designated site; verify that the
location is suitable.
NOTE: Make the cutout as level and smooth as possible. The mounting plate allows
for only minor leveling adjustments. If a larger cutout is made accidentally, consider
purchasing the Crestron Mud Mount Kit, MMK-4L. Together with the mounting
plate supplied with the WMKT-4L, it provide a cost-effective means of correction.
Essentially, the combination of these two kits makes up the Crestron Mud Mount Kit
for the wall, WMKM-4L. Simply follow the “WMKM-4L Procedure” in the latest
revision of the Mud Mount Kits Installation Guide (Doc. 6389).
3. Use the drywall saw or equivalent to produce a level, rectangular cutout in
the drywall as shown on page 3 or 4.
6
•
Trim Ring Mount Kits: TMK-4L & WMKT-4L Installation Guide – DOC. 6390A