Trim Ring Mount Kits
Crestron
TMK-4000L & WMKT-4000L
3. When the trim ring is in position, bend the top two flanges of the ring
upward and the bottom two flanges downward.
•
If mounting into the PMK-4000L, bend the flanges
approximately 90 degrees.
•
If mounting into the BB-4000L, bend the flanges back as far
as they can go.
4. Run the necessary cables for the touchpanel and secure them behind the
drywall.
5. The TPS-4000L can be installed using the four tapped holes in the
PMK-4000L or BB-4000L. Refer to the latest revision of the
TPS-4000L Operations Guide (Doc. 6301) for details.
WMKT-4000L Procedure
The procedure in this section provides the necessary steps for installation of the
WMKT-4000L into a wall. Complete the steps in the order provided. The only tools
or materials required and not supplied are a drywall saw or equivalent and a level.
1. Locate an area on the wall that is free of miscellaneous wiring and
studs.
2. Make a small hole near the middle of the designated site; verify that the
location is suitable.
NOTE:
Make the cutout as level and smooth as possible. The mounting plate allows
for only minor leveling adjustments. If a larger cutout is accidentally made, consider
purchasing the Crestron Mud Mount Kit, MMK-4000L. It and the mounting plate
supplied with the WMKT-4000L provide a cost-effective means of correction.
Essentially, The combination of these two kits makes up the Crestron Mud Mount
Kit for the Wall, WMKM-4000L. Simply follow the “WMKM-4000L Procedure” in
the latest revision of the Mud Mount Kits Installation Guide (Doc. 6303).
3. Use the drywall saw or equivalent to produce a level, rectangular cutout
in the drywall (refer to the Drywall Cutout dimensions on page 2 for
cutout dimensions.).
4. Insert the symmetrical trim ring into the opening, as shown in the
following diagram.
4
•
Trim Ring Mount Kits: TMK-4000L & WMKT-4000L Installation Guide – DOC. 6302