Crestron
TMK-3000L & WMKT-3000L
Trim Ring Mount Kits
Installation
This section provides an installation procedure for each Trim Ring Mount Kit. The
procedure for the TMK-3000L starts below and the “WMKT-3000L Procedure”
starts on page 4.
TMK-3000L Procedure
The procedure in this section provides the necessary steps for the assembly of the
TMK-3000L to either the PMK-3000L or BB-3000L. It is assumed that the
PMK-3000L or BB-3000L has been secured to the stud according to the procedures
in the latest revisions of their respective Installation Guides (Doc. 6024 and Doc.
6022, respectively). Also, it is assumed that drywall is in place and a rectangular
cutout for the touchpanel is made in the drywall (refer to the Drywall Cutout
dimensions on the previous page for cutout dimensions).
Complete the steps in the order provided. The only tool required and not supplied is
a level.
NOTE:
When installing into the PMK-3000L, verify that the 18 AWG bus wire
securing the cables for the touchpanel remains attached.
1. Verify that the rectangular cutout in the drywall is as level as possible.
2. Insert the symmetrical trim plate into the opening, as shown in the
illustration after this step.
Insert Trim Plate into Opening
TRIM PLATE
IMPORTANT:
PLEASE MAKE DRYWALL CUTOUT AS
LEVEL AND CLEAN AS POSSIBLE.
THE MOUNTING PLATE ALLOWS FOR
ONLY MINOR ADJUSTMENT OF TPS-3000L.
3. When the trim plate is in position, bend the top two flanges of the plate
upward and the bottom two flanges downward.
•
If mounting into the PMK-3000L, bend the flanges
approximately 90 degrees.
•
If mounting into the BB-3000L, bend the flanges back as far
as they can go.
NOTE:
If using BNC connectors (supplied by others), the flanges may need to be
bent out of the way
Installation Guide – DOC. 6020
Trim Ring Mount Kits: TMK-3000L & WMKT-3000L
•
3
