Crestron STX-1600C, Руководство по эксплуатации

Страница: 14 / 36

CRESTRON
STX Touchpanel Hardware Hook-Up Diagram (No CN-RJ11)
POWER
PACK
(OPTIONAL)
CONTROL
SYSTEM
LEFT SIDE VIEW
OF STX TOUCHPANEL
PC
SERIAL
PORT
NOTE:
UNITS IN THIS ILLUSTRATION
ARE NOT DRAWN TO SCALE.
Configuring the Touchpanel
It may be necessary to make adjustments or configure the touchpanel due to
utilization or a particular appearance chosen by the user. To configure STX
touchpanels, it is necessary to access a series of setup screens prior to viewing run-
time screens that are loaded into the touchpanel for normal operation. The Main
Menu for configuring the touchpanel appears when a finger is held to the
touchscreen as power is applied. Remove your finger when the message “SETUP
MODE” appears on the touchscreen. Holding a finger to the touchscreen for five
seconds after the “SETUP MODE” message is displayed sets the brightness to high
and the contrast to a safe value (STX-3500C does not offer contrast adjustment).
NOTE: The firmware (required for configuring the touchpanels) is identical for the
STX-3000 and STX-3500C. Therefore, all screens, except for one (contrast
adjustment on the Setup Menu), are identical. Firmware for the STX-1600C differs
completely, except for the Main and Calibration Menus. In this guide, differing
screens are shown side-by-side with STX-1600C screens on the left and the
STX-3000 and STX-3500C screens on the right.
The Main Menu, shown after this paragraph, displays four buttons: TOUCH
SCREEN CALIBRATION , SAVE SETUP AND RUN PROGRAM , SETUP ,
and DIAGNOSTICS .
Main Menu
Calibration Menu
Calibration of the touchscreen is required if the active touch area of a button does
not coincide with the button’s image. Select the
TOUCH SCREEN
CALIBRATION button on the Main Menu to display the Calibration Menu, shown
on the next page. The Calibration Menu offers the choice to initiate calibration with
10
•
Series STX Touchpanels Operations Guide - DOC. 5716A