Crestron QuickMedia QM-RX, Руководство по эксплуатации

Страница: 17 / 48

Crestron QM-RX QuickMedia™ Receiver
Identity Code
Every equipment and user interface within the network requires a unique
identity code (Net ID). These codes are two-digit hexadecimal numbers from 03
to FE. The Net ID of each unit must match an ID code specified in the SIMPL
Windows program. Refer to “Setting the Net ID in Device Settings” on page 26
for details of the SIMPL Windows procedure.
The Net ID of the QM-RX has been factory set to 05 . The Net IDs of multiple
QM-RXs in the same system must be unique. Net IDs are changed from a
personal computer (PC) via the Crestron Installer’s Toolbox.
NOTE: For detailed information on establishing communication between the
PC, control system, and the QM-RX, refer to “Communication Settings” on
page 33. If communication cannot be established, refer to the “Troubleshooting
Communications” section in the latest version of the 2-Series Control System
Reference Guide (Doc. 6256), which is available from the Crestron website.
The Installer's Toolbox provides several methods to easily set or change device
Net IDs for any device on the network. The following method permits you to
change the Net ID of any device in the network through the “Network Device
Tree” window.
NOTE: This method prevents you from setting duplicate IDs.
This method permits you to manually set the Net ID for any device in the
network, can be used to set any known Net IDs that may require changing, and
may also be used for non-TSID equipment. This method will not permit you to
choose an ID already in use by another device. A warning message will appear
if you attempt to use an ID that is already in use.
Duplicate Net ID Warning Message
This method does not change the Net ID as assigned in SIMPL windows.
NOTE: You may also use SystemBuilder to perform Network ID setup. Refer
to page 24 for Net ID setup details using SystemBuilder.
1. Ensure that all network devices are connected to the control system.
2. Open Installer’s Toolbox and select the Network Device Tree
icon, or select Tools | Network Device Tree .
3. Select the connection using the pull down list or click “Click here to
select connection…” to open the address book.
Operations Guide – DOC. 6333 QuickMedia™ Receiver: QM-RX ●
13