Crestron QM-RMCRX-BA, Руководство по эксплуатации

Страница: 40 / 76

QuickMedia™ Receiver/Processor Crestron QM-RMCRX-BA
Step 1 – If the text is blurred and the text color persists (smears) into the blank
space after the text, this is "black streaking" and you need to increase the
peaking value. If you see white bands persisting after the text or you see small
white areas after the text, you have "white streaking" and you need to decrease
the peaking value.
Black and White Streaking
Step 2 – If you see "blooming" or pixel areas that appear larger than normal, you
need to decrease the boost.
Step 3 – The QM skew bitmap consists of two sets of three vertical lines of red,
green and blue positioned directly over one another. The amount of skew is
determined by observing which line is shifted farthest to the right. The line
farthest to the right has the most skew delay. Adjust the other two lines by
increasing their skew so that they all line up. In the following example, increase
red and blue to match green.
Step 4 – The crosshatch test pattern is displayed. Re-check your adjustments.
Lines should appear crisp and all white. If there are color outlines, return to the
skew adjustment. If they are smeared, perform peak and boost again. If they are
unstable, check for induced noise.
•
If you see any color outlines, return to the skew adjustment.
•
If the lines appear smeared, return to the peaking and boost
adjustments.
•
If the lines are unstable and exhibit some crawl, check the system for
induced noise.
NOTE: An image that is not horizontally or vertically centered indicates that an
adjustment of the monitor or projector is needed, and is not a problem with the
Crestron QM system.
NOTE: All presets are immediately stored to the QM-RMCRX-BA, even those
on other screens. There is no need to explicitly save them.
NOTE: You may also use the browse button to load third-party video test
patterns (if installed).
For additional details, download SystemBuilder from the Crestron website and
examine the extensive help file.
Setting Network IDs in SystemBuilder
SystemBuilder provides several convenient methods of selecting and assigning
Net IDs to devices. Net IDs may be assigned while configuring the system, or
after completing the program. The following procedure permits you to change
and reassign device Net IDs after completing the program.
1. After completing your SystemBuilder program, click the Build and
Upload button .
2. Ensure that all network devices are connected to the control system.
36
•
QuickMedia™ Receiver/Processor: QM-RMCRX-BA Operations Guide - DOC. 6332