Crestron NAT, Справочное руководство

Страница: 13 / 22

Crestron NAT 2-Series Feature
Configure the following values:
Host Name
Assign an easy-to-remember identifier in the Host Name field. Rather than having to
recall IP address of the control system, the Host Name identifies the system. Host
name assignment is completely arbitrary, therefore be descriptive as possible.
However, valid characters are ‘0’ to ‘9’, ‘A’ to ‘Z’, ‘a’ to ‘z’, and ‘-‘. The maximum
length is 64 characters. Leaving the field blank will not deter operation.
Firmware Version
No entry is necessary. The firmware version of the 2-Series processor is provided for
reference only.
WAN IP Address
Specify the IP address of the control system (marked as LAN A on the Ethernet
card). This control system IP address is visible to the public. Obtain the subnet mask
and default gateway addresses from the IT personnel. Enter the values into the
appropriate fields.
NOTE: The MAC Address is automatically provided and is determined by the
loaded firmware.
NOTE: Unlike the Crestron Viewport, the subnet mask is not set up automatically.
LAN IP Address
Specify the IP address of the control system (marked as LAN B on the Ethernet
card). This IP address exists only on the private side of the router. Obtain the subnet
mask from the IT personnel. Enter the value into the appropriate field.
NOTE: The IP address for the LAN is arbitrary (exception: no one else’s equipment
resides there). If there is uncertainty, Crestron recommends 192.168.xxx.xxx (a
commonly used class C address).
Remote Management
If enabled, remote management allows the NAT configuration to be accessible from
WAN (external network). Chose Disable to make it accessible locally. This is the
only command that does not require a reboot of the control system.
NOTE: After the appropriate setup fields are complete, click Apply . The control
system needs to reboot. A series of windows, shown below, appear to initiate the
process. Otherwise, click
Cancel .
Reboot Process
Reference Guide – DOC. 6001 Network Address Translator: NAT
•
9