Crestron e-Control, Справочное руководство

Страница: 21 / 74

Crestron e-Control
®
Software
3. Enter the default router address. In residential applications, this is the internal
LAN address of the router, not the WAN IP address that is visible to the
outside. In the example above, the default router address is 192.168.1.1,
which is the default address used by router manufacturers such as Linksys. If
data will not be routed to outside subnets, you can set the default router
address to 0.0.0.0.
4. When you are satisfied with the IP settings click OK to reboot the control
system.
2-Series Control Systems
C2ENET-1 and C2ENET-2 cards: The C2ENET cards provide two configuration
options: one for LAN A and the other for LAN B. With the C2ENET-1 card, values
should only be entered for LAN A.
For static IP addressing , enter the IP information just as described for the CNX-
ENET and CNX-ENET+ cards.
1. Enter the static IP address of the control system.
2. Enter the subnet mask.
3. Enter the default router address (if data will not be routed to outside subnets,
this value can be set to 0.0.0.0).
In the following example, the control system will be set to the IP address
192.168.1.4. The subnet mask is the default for that address class (Class C),
255.255.255.0, and the default router address will be set to 0.0.0.0.
Reference Guide – DOC. 6052 Crestron e-Control®
•
17