Crestron DIN-GWDL, Руководство по эксплуатации продукта

Страница: 14 / 40

Product Manual — Doc. 9096A DIN-GWDL and DIN-GWDL-SPLTR • 14
DIN-GWDL-SPLTR Specifications
Product specifications for the DIN-GWDL-SPLTR.
Product Specifications
Supported Fixtures
Crestron light fixtures
Crestron compatible third-party light fixtures
Communications
DMX-C Supports discovery, auto-addressing and fixture data;
DMX-C communications with Crestron light fixtures and Crestron compatible
third-party light fixtures
Connections
9-48VDC (1) 3-pin 5.18 mm terminal bock;
9 - 48VDC, 4 W Max;
DMX IN (1) 3-pin 5.18 mm terminal bock;
Connect to DMX 1 or DMX 2 of DIN-GWDL
Termination:
Terminate the connection to a DIN-GWDL-SPLTR with the 120 Ω termination
resistor included with the DIN-GWDL-SPLTR between the + and - pins on the
terminal block that connects to DMX IN
OUT 1-4 (4) 3-pin 5.18 mm terminal blocks;
Isolated DMX-C outputs;
One universe split between four ports;
Each output supports up to 32 directly connected devices
Wiring:
Use shielded CAT5 wire or better with a shielded connector, do not connect
drain to ground;
24 AWG minimum;
RJ-45 to 3-pin adapters included to make CAT5 STP connections;
Daisy chain all fixtures, do not create loops;
1,000 ft (305 m) maximum per output
Termination:
Terminate all daisy chain runs with the termination resistor included with the
fixtures
Controls and Indicators
RESET button (1) Recessed push button for software reset
PWR LED (1) Red LED indicates operating power is supplied