15 Inch Lectern Touchpanel
Crestron Isys™
TPS-6000L
hexadecimal number can range from 03 to FE and must correspond to the NET ID
set in the SIMPL Windows program of the Cresnet system. Matching IDs between
touchpanel and SIMPL Windows program is required if data is to be successfully
transferred. NET ID is factory set to 03.
Two side-by-side buttons beneath the hexadecimal display,
DOWN
and
UP
,
decrease and increase the ID by one, respectively.
The touchpanel usually communicates with a Cresnet system. Occasionally the
touchpanel can be used in a demo mode where it merely displays various menus, but
does not communicate with Cresnet II system. In demo mode, the directory buttons
change pages, but buttons requiring feedback do not work. Two side-by-side buttons
above the CRESNET ID,
Enable CRESNET II
and
Disable CRESNET II
,
determine communication mode. Select
Enable CRESNET II
for normal Cresnet
communication mode and
Disable CRESNET II
to set the touchpanel into demo
mode. Text within the selected button changes color from black to red.
Communication mode is factory set to
Enable CRESNET II
.
There may be Ethernet devices on the network that communicate with the control
system via CIP (Cresnet Internet Protocol). Two buttons in the top left corner of the
Interface Menu determines if the touchpanel is capable of this type of
communication. Select
Enable CIP
to permit this protocol recognition and
Disable
CIP
to prohibit any CIP connection.
The Interface Menu allows for four RS-232 communication options: console (i.e.,
loading programs), control (i.e., non-Crestron device), mouse input, or external touch
screen input. The four buttons in the upper right corner of the menu are available for
selection.
Crestron suggests that even if there is no intent to use the RS-232 port, the user
should select one of the four RS-232 communication options. Crestron recommends
the default,
RS-232 Port for Console
, if the port is not being used. If the panel is not
operating within a Cresnet system, it is possible to use Control or perhaps CIP
(Ethernet). Some advanced users may combine Control or CIP with Cresnet. Text
within selected buttons change color from black to red.
It is possible to maintain touchpanel control (with the
Touch Screen Input
button)
while communicating via RS-232 with the console or non-Crestron device. Text
within the selected button changes color from black to red. The
Touch Screen Input
button is repeated on the RS-232 Menu for convenience.
Select the
Save and Return
button, located at the bottom right corner of the
Interface Menu, after interface parameters have been set.
RS-232 Menu
RS-232 parameters, shown after this paragraph, must be set when communicating via
the RS-232 port. Options for baud rate, data bits, parity, stop bits, and handshaking
are available. Text within the selected button changes color from black to red.
14
•
15 Inch Lectern Touchpanel: Crestron Isys™ TPS-6000L
Operations Guide - DOC. 5825