Crestron CAGE2, Руководство по установке

Страница: 12 / 16

3-Card Expansion Cage for AV2 Crestron CAGE2
10. Refer to the diagram below. Re-install the the four rear-mounting SEM
(attached washer) screws that were removed in step 4 to finger-tight
then, using a #2 Phillips tip screwdriver tighten the screws an
additional
1/8-turn .
CAGE2 Installation (9 of 11) - Re-install Rear-Mounting Screws
11. Position cover onto the AV2.
NOTE: The AV2 cover side screws are 0.375 in long and the cover top screws are
0.250 in long. Make sure that the correct screws are re-installed in the cover side and
top, respectively.
12. Refer to the diagram below. Re-install the six cover screws that were
removed from each side of the AV2 in step 2 to finger-tight then,
using a #2 Phillips tip screwdriver tighten the screws an additional
1/8-turn .
CAGE2 Installation (10 of 11) - Re-install Cover Side Screws
13. Refer to the diagram on the next page. Re-install the four cover screws
that were removed from the top of the AV2 in step 1 to finger-tight
then, using a #2 Phillips tip screwdriver tighten the screws an
additional
1/8-turn .
8
•
3-Card Expansion Cage for AV2: CAGE2 Installation Guide - DOC. 5964