12 • CAEN-UMP1X2-DIN-PWS
Product Manual — Doc. 9310A
l
Ground wire with ring connectors
l
One screw
To wire the DIN rail products:
WARNING: To avoid fire, shock, or death, turn off power at circuit breaker or fuse and test
that power is off before wiring!
1. Connect the 2-wire cable from the DIN-AP4 PWR input (2-pin terminal block) to the
DIN-PWS30-277 power output (flying leads).
Ensure the wires to the DIN-PWS30-277 terminals are fully inserted:
l
Connect the black wire to the - (negative) terminal using a small, flat-head
screwdriver. Tighten to 3 in.-lbs (0.34 nm).
l
Connect the red wire to the + (positive) terminal using a small, flat-head
screwdriver. Tighten to 3 in.-lbs (0.34 nm).
2. Connect the NET output on the DIN-AP4 to the NET HOST input on the DIN-HUB using
the 4-wire cable.
Match the terminals for both devices:
l
24
l
Y
l
Z
l
G
3. Use the tie wraps to secure loose wires from steps 1 and 2. Cut off any excess of the wrap.
