Multi-Type Network Distribution Block
Crestron
C2N-HBLOCK
C2N-HBLOCK Ports
The C2N-HBLOCK contains three types of ports that are connected in
parallel. The eight 3.5mm, 4-pin connectors (labeled
1
,
2
,
3
,
4
,
5
,
6
,
7
and
8
) and the five 5mm, 4-pin connectors (labeled
A
,
B
,
C
,
D
and
E
) are
used to connect the C2N-HBLOCK to other four-wire Cresnet devices.
The three 6-pin RJ11 modular ports (labeled
a
,
b
and
c
)
are used to
connect the C2N-HBLOCK to modular devices in the Cresnet system.
Only one port (any of the three types) is used as an input source and the
remaining ports are used as outputs.
CAUTION: Do not connect or daisy-chain more than one power
input (power pack or power supply) to the C2N-HBLOCK. Multiple
power inputs may damage one or more power packs and/or power
supplies.
NOTE:
When using the C2N-HBLOCK to output power to other
devices, do not exceed the maximum capacity of the power pack or
power supply. Calculate and add the total power requirements for all
devices drawing power from the C2N-HBLOCK. If necessary, use
additional C2N-HBLOCKs and power packs or power supplies.
C2N-HBLOCK Indicators
There are three LED indicators located on the C2N-HBLOCK front
panel. The LEDs are described in the next three paragraphs.
POWER
This LED (green) is
brightly illuminated
when Cresnet 24VDC power
is supplied to the C2N-HBLOCK and available at the remaining
connectors.
Y
During normal operation, this LED (red) is
brightly illuminated
when
the C2N-HBLOCK receives the correct Cresnet
Y
data signal. If this
LED is anything other than brightly illuminated, refer to “Y and Z LED
Illumination” on page 9 for further information.
Z
During normal operation, this LED (red) is
dimly illuminated
when the
C2N-HBLOCK receives the correct Cresnet
Z
data signal. If this LED is
4
•
Multi-Type Network Distribution Block
Operations & Installation Guide – DOC. 8157A
Содержание C2N-HBLOCK
Страница 1: ...Crestron C2N HBLOCK Multi Type Network Distribution Block Operations Installation Guide ...
Страница 4: ......
