Back Box Crestron
BB-6000
4
••
Back Box: BB-6000
Installation Guide - DOC. 5826
13.
Tighten four screws installed in steps 10 and 12 by hand. Be careful not
to crack gypsum board.
14.
Verify that the rim of the back box is recessed approximately 1/8" from
the mounting surface and tighten six screws installed in step 2 with a
torque of 11 in-lbs (1.243 N*m).
15.
If touchpanel is available, secure touchpanel to BB-6000 using eight
pan head screws (1” length), supplied. Tighten screws by hand being
careful not to crack gypsum board.
Post-Construction Method
The only tools required are a gypsum board saw (or equivalent), a drill with
adjustable torque, a #2 Phillips tip bit, a 5/16” bit, and a #20 bit. Complete the
following installation procedure in the order provided.
1.
Locate an area on the wall or other suitable mounting surface that is
clear of studs, wires, and other obstructions.
2.
Make a small hole near the middle of the designated site; verify
location is suitable.
3.
Fasten cutout template, supplied, to mounting surface; verify that the
template is level.
4.
Cut out and remove the traced shape of mounting surface.
5.
Drill four 5/16” holes as marked on template. Refer to "Cutout Detail
of Supplied Template" on page 7 for an illustrative reference.
6.
Drill 12 holes marked “A” on template with #20 bit. Refer to "Cutout
Detail of Supplied Template" on page 7 for an illustrative reference.
7.
Slide one metal mounting bracket through the opening and position it
inside along the top horizontal edge.
8.
Position one metal mounting plate along the top horizontal edge so that
it covers the two center holes marked “A”.
9.
Use two pan head screws (1” length), supplied, to secure the bracket
and plate to the mounting surface. Tighten by hand; do not fully tighten
screws.
