8
3.
Predetermine what angle the first VR112 cabinet will be used in, 0 or 2.5 degrees. Remove the pin
from the Lock Pin hole on the Angle Slider Bracket. Adjust the Angle Slider Bracket until the angle ar-
row lines up with the desired angle point as shown by the arrow labeled Angle on the Angle Slider Rail.
The Ground Stack Kit will only allow for the first cabinet to be adjusted to the angles of 0 degrees and 2.5
degrees.
Insert the pin into the Angle Pin hole. This sets the angle of the cabinet to desired angle. See Fig. 15.
Figure 15
4.
With help from a second person, lift the VR112 MKIII Cabinet and place it on top of the sub, engag-
ing the Ground Stack Brackets on the top of the cabinet. See fig 16 and 16a
Figure 16
Figure 16a
5.
Maneuver the cabinet by hand to allow the holes on the Strap Stacking brackets and
the cabinet bottom strap slots to line up. This can be achieved easily by carefully setting the cabinet down
initially lining up the Strap Slots on the cabinet with the Strap Stacking Brackets. Also, lining up the
Rear
Pivot Bar Bracket with the Angle Slider Bracket on the cabinet. Raise the cabinet up so the front is
parallel with the surface of the sub and pin first one side than the other. See Fig 17
