Programmable Input with Priority Page
Vosc Input for Load Monitor
CH A Power Amp
CH B Power Amp
Level
Gain
Gain
Page
Input
CH A
In
+
-
G
Atten
Atten
CH B
In
+
-
G
Page
Enable
Relay
B L O C K
D I A G R A M
Crest Audio Inc.
100 Eisenhower Dr., Paramus NJ 07652 USA
TEL
: 201.909.8700
FAX
: 201.909.8744
http://www.crestaudio.com
Printed in USA
N C - I P E
I n p u t P r o c e s s i n g M o d u l e
S P E C I F I C AT I O N S
Input impedance:
25k
Ω
Signal-to-noise ratio:
105dB
Common mode rejection:
100dB
Frequency response:
20Hz-20kHz
Programmable gain range:
0 to -83dB
Voltage gain/input sensitivity:
X20 (26 dB),
X40 (32 dB),
or constant sensitivity for full output at 0dBu (.775V) int
Connectors:
Balanced inputs
(Channel A, Channel B, and page)
on barrier strip connector
with 0.325" (8.3mm) screw center,
0.270" (6.9mm) lug space,
5mm 2-pin Phoenix page enable connector,
RJ-14 (‘RJ-11 6-pin’) N-Coder data port
Controls:
2 gain attenuators (w/removable knobs)
v. 2.1
4/7/97
Crest Audio reserves the right to make improvements in manufacturing or design which may affect specification. Crest Audio specification literature is available in electronic form to qualified users.
Contact Crest Audio Inc. for more information. NexSys is a registered trademark of Crest Audio Inc. ©1996 Crest Audio Inc.
*A3300023*
C O N T R O L O P T I O N S
The following NC-IPE parameters can be
controlled by the hand-held N-Coder, N-
Coder/PC software, or via NexSys soft-
ware.
N-Coder:
Channel A & B attenuation, phase reverse
N-Coder/PC software:
Channel A & B attenuation, phase reverse,
muting
NexSys computer control:
Channel A & B attenuation, phase reverse,
solo, muting, input and output VU metering
