Crest Audio IPA 2300, Руководство пользователя

Страница: 3 / 8

3
(1) ACL/Mute Indicator
This LED will illuminate red when the signal in the power amplifier reaches the point where the ACL circuit (Automatic
Clip limiter) engages. The ACL circuit reduces the gain automatically when necessary. This indicator will also light
whenever the “Mute All” input is activated.
(2) Amplifier Signal Indicator (SIG)
This LED illuminates green to indicate signal presence at the amplifier.
(3) Power Indicator
This LED illuminates when IPA is powered and active.
Front Panel
IPA 2300
POWER
SIGNAL
ACL/MUTE
PROFESSIONAL SERIES INSTALLATION POWER AMPLIFIER
TM
1
6
4 5 7 12 11 11
8 9 13 10
2
3
Rear Panel
LEVEL
CH. 2
(summed)
CH. 1
MIC
LINE
INPUTS
MUTE THRESHOLD
OFF
MAX
1
-80 0 dB
-1
-3
-6
-10
-15
-30
LEVEL
2
-80 0 dB
-1
-3
-6
-10
-15
-30
POWER
ON
50/60Hz
65 WATTS
Consumo de energia 65Wh
MADE IN CHINA
DESIGNED AND ENGINEERED IN U.S.A.
A PRODUCT OF CREST AUDIO INC.
5022 Hwy 493
MERIDIAN, MS 39305
100 -120V
220-240V
FUSE
100 -120V
T6.3AL/250V
220-240V
T3.15AL/250V
FUSE MUST BE CHANGED
FOR 100 -120V OPERATION,
TO T6.3AL/250V
FUSE MUST BE CHANGED
FOR 220-240V OPERATION,
TO T3.15AL/250V
CLASS 2 WIRING
OUTPUTS
CAN-ICES-3(A)/NMB-3(A)
- - Apparatet må tilkoples jordet stikkontakt.
(For Norway only)
- - Apparaten skall anslutas till jordat uttag.
(For Sweden only)
- - Laite on liitettävä suojamaadoituskoskettimilla
varustettuun pistorasiaan. (For Finland only)
CAUTION
WARNING:
OR ELECTRIC SHOCK, THIS APPARATUS
LIQUIDS, SUCH AS VASES, SHOULD NOT
SHOULD NOT BE EXPOSED TO RAIN OR
MOISTURE AND OBJECTS FILLED WITH
TO PREVENT THE RISK OF FIRE HAZARD,
BE PLACED ON THIS APPARATUS.
REPLACE WITH SAME TYPE 250 VOLT FUSE.
TO REDUCE THE RISK OF FIRE
DANS LE BUT DE REDUIRE LES AVIS:
ELECTRIQUE, CET APPAREIL NE DOIT PAS
RISQUES D’INCENDIE OU DE DECHARGE
ETRE EXPOSE A LA PLUIE OU A L’HUMIDITE
ET AUCUN OBJET REMPLI DE LIQUIDE, TEL
QU’UN VASE, NE DOIT ETRE POSE SUR
CELUI-CI. REMPLACER PAR UN FUSIBLE DE
MEME TYPE ET DE 250 VOLTS.
AVIS:
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
This device complies with Part 15 of the FCC Rules.
including interference that may cause undesired operation.
(2) this device must accept any interference received,
(1) this device may not cause harmful interference, and
Operation is subject to the following two conditions:
25V
4 Ohm
100V
IPA 2300
TM
COM
70V
- - Apparatets stikprop skal tilsluttes en stikkontakt med jord,
som giver forbindelse til stkproppens jord. (For Denmark only)
+ _ G
MUTE ALL
FUSE FUSE
(4) IEC Inlet Connector
This receptacle is for the IEC line cord (included) that provides AC power to the unit.
Please read this guide carefully to ensure your personal safety as well as the safety of your equipment. Never break off
the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a ground pin, a
suitable grounding adapter should be used and the third wire should be grounded properly. To prevent the risk of
shock or fire hazard, always be sure that the mixer and all other associated equipment are properly grounded.
(5) Fuse Holder
The fuse is located within the cap of the fuse holder. If the fuse fails, IT MUST BE REPLACED WITH THE SAME
TYPE AND VALUE NOTED ON THE BACK OF THE UNITS FOR THE SELECTED LINE VOLTAGE IN ORDER TO
AVOID DAMAGE TO THE EQUIPMENT AND TO PREVENT VOIDING THE WARRANTY. If the amp repeatedly
blows the fuse, it should be taken to a qualified service center for repair.