Step 1: Attach Wall Plate to Wall
A. INSTALLING IN DRYWALL (TIMBER FRAME) – SEE FIGURE 1A
WARNING: If attaching this TV Wall Mount using this method, you MUST spread the wall plate across 2
wall studs. Wall studs can be 450mm or 600mm apart depending upon the position of the wall and the
geographical state you live in. The Crest Company will not accept any damages that may occur if only 1
stud is used.
The Crest Company holds no responsibility for incorrectly installed TV Wall Mounts.
1. Locate the centre of two adjacent timber studs. Crest recommends the use of a stud finder (not included).
(NOTE: You must use the centre of the stud to avoid cracking or splitting the timber during installation).
2. Mark a minimum of 4 fixing holes over stud centres using the wall plate as a guide (2 at either end of the wall plate).
Ensure wall plate is level.
3. Pre-drill holes to a minimum depth of 55mm using a high speed 4.5mm drill bit. If installing in hardwood, larger diameter
and deeper holes may be required.
4. Attach the wall plate using the lag bolts (Item W-A) through the washers (Item W-C). Do not over tighten.
B. INSTALLING IN MASONRY – SEE FIGURE 1B
WARNING: Ensure you have a minimum of 35mm of actual concrete/brick thickness in the hole for the
anchors. Do not drill into mortar joints. Installer must verify that the supporting surface will safely
support the combined weight of the TV Wall Mount and TV.
The Crest Company holds no responsibility for incorrectly installed TV Wall Mounts.
1. Mark a minimum of four fixing holes (preferably 6) using wall plate as a guide (two at either end of the wall plate). Ensure
wall plate is level.
2. Pre-drill holes to a minimum depth of 60mm using a 10mm masonry drill bit. Clean out holes.
3. Fully insert the concrete anchors (Item W-B). Tap in with hammer if required.
4. Attach the wall plate by inserting the lag bolts (Item W-A) through the washers (Item W-C) into each concrete anchor
(Item W-B). Do not over tighten.
X
W-A
W-C
ø 4.5mm
(ø 3/16")
55mm
(2.2")
1
3
2
X
X
√
W-A
W-C
60mm
(2.4")
ø 10mm
(ø 3 /8”)
2
1
X
X
√
W-B
1A
1B