ODC CLASSIC XL
TM
ASSEMBLY INSTRUCTIONS
OUTDOOR DISCOVERY CRAFT
TM
I. PLASTIC SEAT ASSEMBLY
1. Assemble Seat Back to Seat Bottom using Seat Assembly Pins (see figure 1a).
II. ASSEMBLE FRAME
NOTE: Your Frame Assembles using (8) Short Snap Pins. Please follow instructions accordingly.
1. Assemble Cargo Deck by slifing Mesh Cargo Deck over Frame Member (see figure 1) and secure using attached Hook and
Loop and Ladder Lock / Strap Fastners.
2. Assemble Seat to Seat Support Frame Member using (4) Seat Screws. (See Figure 1a)
3. Assemble Seat Support Frame Member to Left and Right Frame Members using (4) of the Short Snap Pins. (see figure 1)
4. Assemble Cargo Deck to Left and Right Frame Members using (2) Short Snap Pins (see figure 1).
5 Assemble Foot Bars to Left and Right Frame Members using (2) Short Snap Pins (see figures 1).
II. PONTOON INFLATION
NOTE:
Use double action pumpwith adapters (included), available from the Creek Company
1.
Inflate each Pontoon. The Valve is located inside the Storage Pocket of each Pontoon.(see figure 3).
Inflate until firm (do not over inflate).
PONTOON DEFLATION:
Depress center valve butoon and turn clockwise 1/4 turn to lock open. Depress and turn 1/4 turn counter
clockwise to close the valve.
III. ATTACH PONTOONS TO FRAME
NOTE:
Always inflate the Pontoons first, before attaching to Frame.
1.
Position inflated Pontoons under the Left and Right Frame Members with ODC CLASSIC XL
TM
logos oriented to the
outside.The Frame Members fit around the Storage Pockets.
2
. Attach Pontoons to Frame as illustrated in figures 3 and 3a. Note: Be sure the Straps are pulled tight through the
Cam-lock Buckles. Frame should be positioned forward or aft on the Pontoons to achieve center of gravity for an even
ride when fully loaded on the water.
IV. OAR & OARLOCK ASSEMBLY
1.
Loosen the wingnut on the Oarlock and slide the Oarlock onto the handle end of the Oar Shaft.
2.
Attach blade end of Oar Handle to end of Oar.
3.
Place Oarlock Shafts into Frame.
4
. With the Oarlocks installed on the Frame, the oars should be equally adjusted left and right allowing at least two
thumbs’ distance between the Oars, to avoid pinching your thumbs when rowing. With the blades perpendicular to
the water, tighten the wingnuts.
V. ATTACH STRIPPING APRON TO FRAME
1.
Snap front two Straps around the Frame underneath the Oarlocks, and snap the back two Straps to the Right and Left
Frame Members just behind Storage Pockets.
