ENGLISH
1
The Sequel mk4 fits inside most Creek amplifiers produced since 1993 and suits a wide-range of Moving-Magnet (MM) and high-output Mov-
ing-Coil (MC) cartridges.
It plugs into the pre-amplifier circuit board, in place of the LINK connector. In the case of the Voyage i20 amplifier it MUST be fitted by the supply-
ing dealer, for health and safety reasons. If care is taken to follow the fitting instructions precisely, it can be installed in all other Creek amplifiers
by the user or dealer.
Fitting instructions
It is essential to remove the mains power and other cables from the amplifier. Using a crosshead (Pozidrive) screwdriver, remove screws and
cutting washers around the top cover. Remove the top cover and place it carefully away from the amplifier.
Remove the plug-in 5-way LINK PCB from the Pre-amp section of the amplifier. This makes room for the Sequel mk4 Phono pre-amp to be fitted,
between the 4-way (power supply) and 5-way (input/output) connector. It is not possible to fit the module back to front, but make sure all the
pins on the connecter are lined-up with the sockets on the Phono PCB. The Phono pre-amp can be damaged if it is misaligned when powered-on.
Do not use more gain than is required, as it may overload the Line pre-amp and cause distortion. 40 dB is sufficient for most MM cartridges and
50dB is enough for most high output MC cartridges.
