2 of 2
CI088X03R4
lighting.cree.com
© 2018 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change.
See http://lighting.cree.com/warranty for warranty and specifications. Cree
®
is a registered trademark, and the Cree logo and
Cree Edge are trademarks of Cree, Inc.
DIRECT MOUNT TO 4" SQUARE STEEL SHAFT
STEP 1:
Remove hub cover located at the top of the hub by removing the two
Phillips screws. See
Figure 1
.
STEP 2:
Feed supply conductors through base of hub. Strain relief may be provided
by tying a knot in conductors.
NOTE:
If mounting to 4 inch square aluminum pole with a ¼ inch wall,
discard two shims provided with fixture.
STEP 3:
Slide hub into 4 inch square pole until hub is resting on top of pole.
STEP 4:
Secure fixture to pole by tightening the four mounting bolt to
120 in-lbs (21 N•m).
STEP 5:
Replace hub cover from step 1 after completing electrical connections
section.
ELECTRICAL CONNECTIONS:
PHASE to NEUTRAL WIRING – 120/277/347V
STEP 1:
Make the following electrical connections:
a. Connect supply ground conductor to fixture (green) ground wire
and mounting plate (green) ground wire with wire connector.
b. Connect supply voltage conductor to fixture black wire with wire
connector.
c. Connect supply neutral conductor to fixture white wire with wire
connector.
STEP 2:
Complete fixture installation per mounting instructions.
ELECTRICAL CONNECTIONS:
PHASE to PHASE WIRING – 208/240/480V
STEP 1:
Make the following electrical connections:
a. Connect supply ground conductor to fixture (green) ground wire
and mounting plate (green) ground wire with wire connector.
b. Connect supply L2 (Hot) conductor to fixture black wire with
wire connector.
c. Connect supply L1 (Hot) conductor to fixture white wire with
wire connector.
STEP 2:
Complete fixture installation per mounting instructions.
