INSPECTION AND CLEANING
Check that all the lamps are functioning. If any thermostatic or time controls are fitted
1.
ensure that the supply is ‘on’ before checking lamps. Any failed lamps should be
replaced (see lamp replacement). Remove any accumulated dirt and check wiring and
connections.
Clean the lamp(s) and reflector(s) using a mild detergent solution and soft cloth.
2.
Do not use any abrasive or caustic cleaners. Dry with a soft cloth. Avoid touching
either, the quartz lamp sleeve or the aluminium reflector with bare fingers. If they
are accidentally touched remove any finger prints using a soft cloth moistened with
methylated spirit.
Check that the lamp(s) are properly located in the spring retaining clips and that they
3.
have not been disturbed by cleaning. The lamps should be pushed fully back into the
clips for applying light pressure on the end caps only.
SAFETY IN OPERATION
The heater is operated by simply switching on the electrical supply, or, if used in
conjunction with a control system, then the supplier’s instructions must be observed.
ALWAYS disconnect the heater from the supply before attempting to work on or near it.
NEVER operate the heater with a high accumulation of dust or dirt on the lamp(s) or
reflector or with a damaged or corroded reflector.
This appliance is not intended for use by children or other persons without assistance
or supervision if their physical, sensory or mental capabilities prevent them from using it
safely. Children should be supervised to ensure they do not play with the appliance
NEVER use the heater outside or in contact with water.
NEVER use the heater where flammable dusts, gases or vapours, etc. are likely to be
present in the atmosphere.
NEVER operate the heater in close proximity to the skin or eyes.
NEVER allow materials which could be damaged or ignited by the radiated heat to be
placed in close proximity to the heater.
NEVER cover the heater – even when it is switched off.
ALWAYS refer to these instructions before attempting to dismantle the heater.
AFTER SALES SERVICE
Your product is guaranteed for one year from the date of purchase. Within this
period, we undertake to repair or exchange this product free of charge (excluding
element & subject to availability) provided it has been installed and operated
in accordance with these instructions. Your rights under this guarantee are
additional to your statutory rights, which in turn are not affected by this guarantee.
Should you require after sales service you should contact our customer services help
desk on 0845 6042399. It would assist us if you can quote the model number, series,
date of purchase, and nature of the fault at the time of your call. The customer services
help desk will also be able to advise you should you need to purchase any spares.
Please do not return a faulty product to us in the first instance as this may result in loss or
damage and delay in providing you with a satisfactory service. Please retain your receipt
as proof of purchase.
c] GDC Group Ltd,
All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Dimplex.
A division of GDC Group Ltd,
TEL: 0845 604 2399
FAX: 01489 773064
WEBSITE: www.credaheating.co.uk
Republic of Ireland Tel. 01 8424833
CREDA HEATING
MILLBROOK HOUSE
GRANGE DRIVE
HEDGE END
SOUTHAMPTON
SO30 2DF